SOURCE: Chevy S10 Pick 1995 - Sputters and almost stalls when accelerating.
You could have a dirty EGR valve, you can re move it from the manifold and clean it with Throttle body cleaner. Might as well buy two cans, since your cleaning the EGR, might as well clean out the throttle body too.
Spray the throttle body cleaner in to the throttle body with the engine running and try to keep it at 1000 rpm and then to 1500 rpm as you clean out the throttle body and let it idle down for 2 min then turn the engine off. Then turn the engine to the run position for 10 seconds and start and let idle, ro for a test drive and hope that solved the problem, if not there a few more things we can do which will consist for tune up.
Note: Clean the EGR first so you don't burn your self since the engine would still be cool before you clean the Throttle body.
Good luck and keep me posted.
SOURCE: 98 chevy s10 blazer turn signal
Unplug the turn signal relay from the fuse box and start you engine. Does it still make that noise?
If yes... Put the relay back in, that is not the problem.
If No...Then the relay could be bad, replace it!
PLEASE RATE THIS SOLUTION! Thank You Very Much!
SOURCE: My 98 Chevy Blazer won't
Is there a light on that says security after this happens? Might be flashing? If so, check out this link for info and DO IT YOURSELF solutions.
http://vatspasslockpasskeysecurityhelp.yolasite.com/
SOURCE: 89-98 chevy blazer
It's not worth doing all that conversion, buy the time you spend the time and money to convert the 89 4.3 to work on the 98 blazer, it would be cheaper to install a 98 vortec rebuild. The 89 4.3 have a TBI fuel injection system and the ecm on the 98 will not work and the bad news is that the ecm on the 98 also controls the transmission shift points and the 89 will not, so even if you swap the ecm to have the 89 4.3 engine work. the transmission will not shift. Sorry for the bad news but it would be cheaper to replace the 98 engine with the years of 1996 to 2001. Good luck and hope this helps.
SOURCE: 98 Chevy blazer won't start up but will crank ,,
Try giving it a shot of starting fluid. You don't say if it's actually firing. If it tries or runs for a few seconds off of the starting fluid then try changing the fuel pump relay. It's inside of the glove box on the left hand side behind the little door. If that doesn't work it's most likely the fuel pump.
1,543 views
Usually answered in minutes!
×