How to replace a water pump
For water pump replacement i suggest you to check the help link
provided below. click the link below :---- Water pump replacing procedure for all vehicles? http://technoanswers.blogspot.com/2011/11/water-pump-replacing-procedure-for-all.html HOW TO REPLACE A WATER PUMP http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-water-pump.html ------------------ http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html --------- http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-water-pump-on-acura-car.html --------- http://technoanswers.blogspot.com/2011/12/how-to-remove-water-pump-on-toyota.html ------- http://technoanswers.blogspot.com/2011/12/where-is-water-pump-located-on-toyota.html ----------- This will help. Thanks.
---------
How to route Water Pump Belt for 1992 Oldsmobile ?
How to replace Water Pump on Car ?
How to Remove Water Pump?
Where is Water Pump located ?
SOURCE: 1992 mercury topaz auto/ 4 cyl//
Did you fix this yet?
Are you getting fuel to the plugs?
Try starting the car, then remove one of the plugs. Check for the smell of fresh gasoline. You could also try smelling the exhaust to see if there is a fresh unburt gasoline smell.
If your getting fuel, then the fuel system is probably not the problem.
Are you getting spark to the plugs?
After you replaced the Distributor, did you adjust the timing?
SOURCE: 1992 mercury topaz
I had the same problem. It was the idle air control valve. It sits on top of the intake just downstream from the throttle. There's a valve rod inside that gets worn over time and starts to stick. If that's what is causing your problem, you need to replace the unit.
SOURCE: oil leaking in front of my engine above the oil filter. '92 mercury topaz GS, 2.3 4 cyl
possibly the oil pressure sending unit- looks like a small spark plug screwed into the engine with one wire going to it
SOURCE: Where is the fuel pump relay located on a 1992 Mercury topaz
the fuel pump relay is located on the left shock tower in the engine compartment in a black box 6x4x1 inches. there are other relays inside the same box which is actually called the ccrm or constant contorl relay module, there should be a double connector with 20 to 26 wires in it, hard to miss.
SOURCE: 1992 mercury topaz. Replaced ignition module and
does it have cap and rotor set up? could be one of them
For water pump replacement i suggest you to check the help link
provided below.
click the link below :----
Water pump replacing procedure for all vehicles?
http://technoanswers.blogspot.com/2011/11/water-pump-replacing-procedure-for-all.html
---------
HOW TO REPLACE A WATER PUMP
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-water-pump.html
------------------
How to route Water Pump Belt for 1992 Oldsmobile ?
http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html
---------
How to replace Water Pump on Car ?
http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-water-pump-on-acura-car.html
---------
How to Remove Water Pump?
http://technoanswers.blogspot.com/2011/12/how-to-remove-water-pump-on-toyota.html
-------
Where is Water Pump located ?
http://technoanswers.blogspot.com/2011/12/where-is-water-pump-located-on-toyota.html
-----------
This will help. Thanks
952 views
Usually answered in minutes!
×