First off, don't expect them to just fall off after removing the large nut in the center of the hub. I tried that. Granted, the nut does need to come off, but, after removing the caliper, there's four more bolts that come in from the backside that also need to be removed. This then allows you to remove the front spindle, hub, and rotor as an assembly. Watch your toes! Also note how the dust shield is sandwiched in amongst all of this. Once this assembly is off, the wheel studs can be driven out with a hydraulic press (no small feat), and the rotor falls away from the hub
SOURCE: How to remove rotors on 97 dodge 2500 4x4
mopr is wrong the four bolts he has obviously never done this before. this is a huge pain in the ****. , remove the castle nut and the four bolts on the back side and you will have to drive off the wheel studs to get the bearing/hub assembly off of the rotor. good luck youll need it .
SOURCE: I have 2001 Dodge Ram 2500 4X4 gas engine and it
The problem I had with my '89 Dakota was it would suddenly stop running while driving. After from 10 minutes to an hour I could start it up and drive on. It started happening more and more often. I was in a rush to get the truck running so I replaced both the computer and the timing module in the distributor to fix the problem. However, I suspect the real problem was the timing module was failing causing the engine timing to go out of spec and computer sensed it and shut down the ignition to safeguard the engine.
Good Luck, Bob
SOURCE: How do you change the front universal joints on a
The drive shaft will need to be removed. Remove ujoint cap clips from yolk and shaft. Should be four all together.tap out the u joints.
Remove cap from new ujoint. place into yoke from outside. Slip ujoint inside, attach to cap. press ujoint into housing. do the same with drive shaft side. Dont forget to put the new clips provided, on the shaft and yolk
SOURCE: 2001 dodge ram 2500 v10 oil pressure drops to 0 then back up
you need to put an oil pressure gauge on it and see what happens.what you will find is that the sender unit is no good.
SOURCE: What does code ccd mean on overhead display 1997
It means "Crystal Clear Display"
but in basic term its called a ccd bus, basically the OH console module is not communicating with body control module so you want to check power and ground pins or you just might have a bad module, sorry.
A self-diagnostic test is used to determine that the
compass mini-trip computer module is operating
properly electrically.
CCD communications test.
Following completion of these tests, the compass
mini-trip computer will display one of three
messages: “PASS,” “FAIL,” or “CCd.”
if the “CCd” message is displayed, the use of a
DRBt scan tool and the proper Diagnostic Procedures
manual are required for further diagnosis.
Testimonial: "Many thanks for your expert advice"
1,380 views
Usually answered in minutes!
×