I am replacing the shifter cable in a 1998 Bravada. I picked up the replacement cable from the dealer and there is a blue part, attached near the end that attaches to the transmission, that I am not sure what to do with and there is a white plastic "Lock" that is engaged on the old part that I removed but is disengaged on the replacement cable. I need guidance on how these parts are integrated and why and what to do with them.
SOURCE: fuel pump 1998 olds bravada
If
fuel and vapor hoses or pump/sending unit wiring can be accessed at
this time, they may be tagged and disconnected. If not, wait for the
retaining straps to be loosened and lower the tank slightly for access.
To install:
Equipped With Shield Package
To install:
any question I can send some diagrams
SOURCE: Replace actuator cable for front driver side window motor
I also Have this problem, just happened, is their a way to repace this
SOURCE: whereis the thermostat located on the olds bravada 1998
Follow the top radiator hose to the top of the engine/intake remove the hose and move to the side then take out the two bolts holding the thermostat housing to the intake remove and install the new stat and gasket.
SOURCE: Where is the fuel pressure regulator located at in a 94 bravada
My friend, I suggest you go by your local Auto Parts Store and purchase a Haynes Repair Manual on this vehicle. There are many sensors and electronic controls involved with this engine as I'm sure you already know. Any one of these can memic something that "it is not".
If your problem is the Pressure Regulator, it is located inside the "Tunnel Ram" intake manifold along with the multiport fuel injection system.
Now,,, before I went through the trouble and expense of going into the Intake Manifold, I would run the EMC in Diagnostic Mode and see if there are any codes present.
85 views
Usually answered in minutes!
×