1.8i zetec 16v T reg 1999 head bolt tightening sequence and torque settins
Go to this LINK for the info in pdf format, the sequence is on page 16 of the pdf file.
Testimonial: "Great help...just the info I needed to do job. Thankyou very much."
SOURCE: cylinder head ford zetec escort p reg
Stage 1 = 15Nm
Stage 2 = 40Nm
Stage 3 = Plus 90 degrees or quarter of a turn. Good tip is to mark all the bolts after initial torque setting with tip-ex , i.e. all to the front of the car. When you finish they should all point towards the timing belt.
This is also a good way to make sure you don't miss one or tighten one twice if you are distracted since it is not a torque setting. New bolts should be used by the way as they are stretch bolts. Timing of cams - remove cam cover and you will see a slot on the end of the cams. Opposite end from belt. You need to slip a piece of 5mm flat bar or a long 5mm allen key into then so that the bar rests on the face of the head. Engine should be a tdc.
cheers John
SOURCE: torque settings and sequence for cylinder head
about 80lbs and start in middle and work outwards ,one left then a right side ,another left and so on
SOURCE: My Mk2 Mondeo 2L petrol Black top Zetec engine,
CHANGE SPARK PLUG WIRES..A BAD ONE CAN DO WEIRD THINGS..SOUND LIKE A MISS IN ONE...
SOURCE: i have a 1999 mondeo 2.0 16v zetec which has a
I HAD A 2004 FORD FUCUS THAT WAS DOING THE SAME THING I HAD A HARD TIME WITH IT
IT WAS THE COIL PACK IT STARTED GIVEING RANDOM MISFIRE CODES AND FINLEY NUMBER 4 CYLENDER QUIT FIRING AND THAT WAS THE ONLY REASON I WAS ABLE TO FIGURE OUT THE COIL PACK WAS GOING BAD THE HOLE TIME
I HOPE THIS IS SOME KIND OF HELP YOU CAN TAKE THE COIL PACK TO THE PARTS STORE AND HAVE IT CHECKED YOU CAN DO IT YOUR SELF WITH A VOLTS METER BUT I'M NOT SURE WHAT NUMBER IT IS SUPOSED TO PUT OUT GOOD LUCK!
SOURCE: got a mk2 ford mondeo estate 2.0 16v zetec that
If the car won't turn over your immediate problem is with the starter or the battery. subsequently if you have a bad battery you could also have a bad alternator not charging the battery. You problem isn't with the fuel pump as it does not assist the engine in cranking.
2,483 views
Usually answered in minutes!
Need the sequence and torque settings for head gasket change..can anyone help ?
Thanks for the help... now got the details I needed to do head change. Another vehicle with a daft angle setting on head bolts. Miss my old Cortina..was a dream to work on...even an engine swap could me done on my own without a hoist...lol.
×