Go to a garage and ask him to clear up obd error messages. a good mechanic won't charge you for this favour.
SOURCE: What does the diagnostic computer mean when it
It means your Keyfob remote battery need replacing...
have it replaced at citroen, if you mess it up it can be expensive, rather pay £5 for a battery than £100 for an immobiliser reset...
leave feedback good or bad.
SOURCE: plip battery spent message will
hi this is the battery in your key remote, it is saying it needs to be replaced soon or it will not work so just replace the battery in the fob, be sure to do this in 60 seconds or you will need to re-program the fob, just in case you do not get the battery in, in time, here is how to re-program it as follows
Turn the ignition switch to the ON position using the first key.
Press the LOCK button for 10 seconds.
Remove the key and wait for 10 seconds.
Check the Plip key operation.
Repeat for second Plip key if required.
Turn the ignition OFF
hope this helps please comment and rate thanks
SOURCE: what does this display message mean "plip battery
what does the word plip battery spent mean on a peugeot 307. It says that when i first turn on the ignition.
406
FOB / PLIP PROGRAMMING :
The
406 deadlocking remote control has specific button controls, and if the vehicle
has two controls, one is set as primary and the other as secondary.
When
replacing the Plip, a Primary or Secondary Plip are different part numbers and
must be ordered as required. The white label inside the Plip is labelled PRIM
or SEC.
1.
Turn the Ignition switch ON.
2.
Press the large Plip key button (Primary Plip)
3.
Within 10 seconds press the large Plip key button (Secondary Plip)
4.
If there is one remote, press the Primary plip button twice.
5.
Turn ignition OFF.
6.
Test Plip's for correct operation.
NOTE
: On some 406 models, Plips cannot be re-synchronised unless the battery has
been disconnected for 1 minute
8,773 views
Usually answered in minutes!
the battery in your key remote, it is saying it needs to be replaced soon or it will not work so just replace the battery in the fob, be sure to do this in 60 seconds or you will need to re-program the fob
×