FOR OBD code P1744 on 1997 ford Taurus?Click the link below:---- http://schematicsdiagram.blogspot.in/2012/03/obd-code-p1744-on-1997-ford-taurus.html----------This will help.Thanks.
SOURCE: 1995 Ford Taurus Sho 3.2 check engine light blink
SOURCE: I need a list of the EGR/Trouble codes for a 1994 Ford SHO Taurus
Sounds like the catalytic converter has gone bad. What happens is you car as you drive will lose power, smell like rotten eggs and stall out. The reason is, the cat. is plugged up and cannot let the exhaust out of the tail pipe like it should. The exhaust is staying in the engine causing it to stall out and loose pwer.
SOURCE: I want to turn off
Hi there. As far as the valet/overide button, it's a hidden
device-switch, a little spring loaded micro button,
red or black possibly and is probably down under
the dash area, near your knee/leg. In some
remote start/alarm combos, the antenna on the window
glass will also have an override/valet button.
Older sytems will have a flip type toggle switch.
When you locate the button or switch,
turn on the ignition key, press and hold
in the button until the alarm chirps 1 time
(for toggle types, key on, flip switch in the
opposite direction, then key off). This should over ride the system. You would get a single chirp to confirm from the siren.
The LED (light emiting diode) light in the dash
should also go on solid. This is valet/overide/reset.
This should correct any issues like starter disable,
or anti-hijack. Your keyless entry, if installed,
will still be operable. The have it inspected for the
falsing issues you are experience at a local shop.
You would repeat the same steps to toggle back into user mode.
SOURCE: replace a serpentine belt on a 97 ford taurus
use a 15mm box wrench on the nut retaining the tensioner pulley to pry the tensioner 'arm' against the spring to release belt. note belt routing on decal under hood,or make a sketch,to aid in replacement.
on OHV engine rotate clockwise
on OHC rotate counter clockwise
be sure belt is completely seated on pulleys
SOURCE: where is the thermostat located
For 1997 Ford Taurus 3.4L SFI SHO 8cyl check this diagram...
Fig.: The water inlet connection, O-ring and the thermostat are mounted on the water pump assembly-3.4L DOHC engines (click for zoom)
I hope this helps (remember to rate and comment this answer).
1,259 views
Usually answered in minutes!
×