You searched for "dodge neon 2005 sxt taking a minute to crank an will not go over 2 rpm when gets to 2 rpm it acts as if its back firing also does the same while driving i have replaced crankshaft sensor throttle position senson spark plugs wires ignition coil catalytic converter and fuel pump still hasnt fixed the problem
SOURCE: i need to replace the cam sensor in my 2004 dodge
The part is only $50 and its an easy self do it. The sensor is located right next to the engine on the drivers side. Search the part on Auto Zone see what it looks like and you will be able to locate it
SOURCE: I have a 1996 dodge neon the car starts for about
check power distribution center.if ok you have a faulty ignition component.
SOURCE: 96 Dodge Intrepid ES, engine stalls
Find your firewall electrical junction block (where all the wires enter the cabin on the passenger side) and with a zip tie pull up the wire bundle so it does not ride on the upper tie rods and, fasten the zip tie to anything that is solid in the engine compartment and, let me know what happens
SOURCE: 97 dodge neon died replaced parts and still no spark HELP.
YOU NEED TO CHECK DARK GREEN/ORANGE WIRE AT IGNITION COIL WHEN CRANKING ENGINE FOR POWER..IF NO POWER,SHUTDOWN RELAY IS NOT BEING ENERGIZED..THIS ENGINE ALSO HAS CAMSHAFT POSITION SENSOR ON END OF CYLINDER HEAD..ENGINE CONTROLLER NEEDS CAM AND CRANK SIGNALS TO ENERGIZE THE SHUTDOWN RELAY..UNPLUG CRANK SENSOR AND CHECK VOLTAGE ON ORANGE WIRE..SHOULD HAVE APPROX 8V..IF NOT..UNPLUG CAM SENSOR AND SEE IF 8V SUPPLY RETURNS..IF NO POWER TRY UNPLUGGING VEHICLE SPEED SENSOR LOCATED IN TRANS HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..IF 8V RETURNS..THE SPEED SENSOR IS SHORTED INTERNALLY..THESE 3 SENSORS SHARE THE SAME 8V SUPPLY CIRCUIT..WITH SPEED SENSOR UNPLUGGED,PLUG CRANK SENSOR BACK IN AND TRY TO START ENGINE..HAVE SEEN THIS SAME PROBLEM AT WORK RECENTLY
SOURCE: 2004 dodge neon sxt 2.0l do i need to do a
there is no such thing you need to time the engine correctly
199 views
Usually answered in minutes!
×