Key stuck in ignition

The key switch may be drilled out but the ignition switch may not be ingageing the power it needs for the electrical system ,replace the key cylinder .

You are not the only one:

Key stuck in ignition, wont start, dodge ram pickup - Fixya

www.fixya.com/.../t14560159-key_stuck_in_ignition_wont_start_dodge
Oct 6, 2012 - key stuck in ignition, wont start, dodge ram pickup - Dodge Ram 1500question. ... 631 Answers. SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171. This code means ... Jun 28, 2011 ' 1987 Dodge Ram 50 · 1 Answer .

wont crank or wont start ??? big difference

no start, check ignition module or asd relay
no crank, check everything from battery to ignition switch to cables to fuses

ignition has bent pins
insert key tap it with malat
once key turns take car to lock smith for repair they can sand the pins once fixed remove some of the keys off your ring do not remove key b4 turning after wacking the thing with malat
failing this call mobile lock smith they are still cheeper than dealer and can fix on sight

new ignition from dealer 200 bucks cost to install it at dealer 200 bucks

locksmith will usually charge 50 - 125 to fix curent ignition 125 would include mobile visit usually

Do you have sufficient power to the vehicle? Do the lights work and radio? If not your battery is low, if yes than your starter solenoid may have failed. Since there is absolutely nothing, I take it you hear no cranking or igniting. correct?

recharge battery and try priming it make sure none of the wires are corroded...check fuses

if you turned the key with the ignition with the imobilizer, you now have to get the right ignition and a new PCM because the PCM now thinks the car has SKIM (imobilizer)

Sounds like the ignition cylinder is jambed, if you remove the covers and put the key in, you might be able to turn it with pliers, just turn it to the accessories position, then there is a small metal clip that pushes in, push it in and pull the lock cylinder out of place, get a new one from the dealer and reverse to install. If it's above you, your dealer can help, usually about an hours labour or so.
Hope that helps, Good luck
R

try turning the steering wheel either way at the same time that you try to get the key out

faulty ignition relay staying stuck on and not opening when there is no power from the ignition switch