Can some body giveme the belt layout on a 1995 mercedes benz e320

THE FUES BOX IS UNDER THE HOOD ON THE DRIVERS SIDE IN THE BSCK CONER

ALLDATA shows 4 different diagrams. I posted them below for you. I hope this helps and good luck.

I have two Mercedes - one is 2000 E320 Wagon; other is 1999 E320 Sedan.

I replaced the serpentine belt on my 2000 Wagon today at 92,000 miles. I found that the Motorcraft JK6-947 could be purchased on Ebay for $12.99 plus $6.20 shipping. The old belt was a Goodyear Gatorback 4060940. My 1999 sedan has a Mercedes Benz 011 997 97 92 6K2390 EM7117 Gates belt made in Spain.

Here are the details of replacing the belt.

On the 2000 E320, a 17 mm bolt just under the belt going to the tension pulley will release the belt tension when turned counterclockwise. Removal of the belt was easy after using a 17 mm deep socket wrench similar to a spark plug socket. I made turning the bolt very easy by slipping a 4' pipe over the socket wrench handle. It is advisable to put the new belt LAST on the idler pulley that contacts the belt only on the smooth side.

You do not need todisturb theButton Torx bolt in the center of the tension pully.

The 1999 E320 uses a 15 mm bolt in the CENTER of the tension pulley. Otherwise the installation is the same as the 2000 E320.

Its inside your car manual on the left side as you open it up, it'll be a lil grey card that will have the radio code written on it... read the manual and it'll tell you how to put the numbers in.

mbusa.com , for 2000 year

1. Lock doors via key on Driver's door.2. Disconnect battery.3. Wait a couple minutes to let remaining voltage leak out of system.4. Reconnect battery.5. Unlock doors via key on Driver's door.

This is it

may be a fuse, relay or breaker

you must got to the dealer for a radio code for you benz. sorry

ihave a diesel e320 won't start