SOURCE: Starts fine when cold, after running dies on idle then wont start
Sounds like the fuel filter is dirty and needing to be changed. It's cheap and easy to swap out.
SOURCE: 2001 MAZDA TRIBUTE COLD STARTING PROBLEM
My wifes car had this same problem at about 100000 miles and after many trips to the shop it turned out to be carbor build up in the intake manifold. A fuel injector cleaner was hooked up and it helped the problem, but did not completely solve it. In oreder to get it totally clean the intake had to be removed and clean it out manually.
SOURCE: 2001 checy Tahoe wont stay running for more then 10 seconds?
If its been a while sense you have chg. fuel filter,DO IT, If still does the same after that, do fuel pressure test, fuel pump might be on its way out. $$$$$. If pump and filter chks. out ok, than maybe its fuel regulator. My best guess its either filter or pump.
SOURCE: 99 GMC sonoma will start with starting fluid then
Will the engine start on its own after the engine is warmed up?
Let me know.
Regards,
SOURCE: from cold start engine warms to quater temp then
Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Otherwise, guesswork. I have MANY ideas that could send you on a wild goose chase. I strongly suspect EMS (Engine Management System) sensor beginning to malfunction as it warms up. First strong suspicion is the crank position sensor (CKP) - however,usually always sets a DTC (i.e., P0335, P0336). The next suspicion is the Engine Coolant Temperature sensor. The ECM uses this sensor's signal to adjust fuel, timing, engine RPM, etc based on engine temp. If malfunctioning at a particuar point during engine warm up, it could be telling the ECM the temperature is LOWER or HIGHER than it ACTUALLY is, resulting in the ECM to increase fuel (flood it) or give it LESS fuel (starve it). If this malfunction lasts long enough, the ECM will usually set a DTC for that sensor circuit, either a Range/Performance code, or a "LOW Input" or "HIGH Input" code.
375 views
Usually answered in minutes!
×