Changing bearings,oil rings,big ends mains
SOURCE: hyundai elantra 1.6GLS J2 torque settings
dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm
SOURCE: torque wrench settings for 97 hyundai lantra 1.8
They use throw away bolts. One use only, so don't reuse your old ones. You will need new ones. The smaller bolts 1st torque setting 22Ft/Lbs and the larger 26ft/lbs, the 2nd torque setting 60 degrees both bolt sizes and the 60 degrees for the third.
SOURCE: Hyundai Tucson cylinder head Installation
dear friend:as this is a very serious job your attempting,i would suggest you get hold of a workshop manual,plse look at the following web sites: BOOKS4CARS.COM and WWW.HMASERVICE.COM
SOURCE: hello i have a 2008 hyundai accent gls. it has
Get it scanned. You should be under warrantee. Otherwise most auto parts stores will do this. Could be as simple as a loose gas cap.
SOURCE: my hyundai accent piston rings need a change how
If it needs rings, it probably needs a lot of other engine work, like a cylinder hone, or if it's out of spec, a bore, which means new pistons and on. You might look into a good remanufactured engine that comes with a warrantee if your has a ton of miles on it.
1,562 views
Usually answered in minutes!
×