You must have a spare key. When your alarm is going off have your key in the ignition, wait it out. When your alarm stops in approximately 30 seconds keep the key in the ignition exit the vehicle and lock the doors (don't forget your spare key). Go to the passenger door with the spare key and unlock the doors and turn the key that you left in the ignition and it should start right up. Just worked for me.
SOURCE: 2003 hyundai tiburon alarm system
factory fitted alarm?? no way its done through the ECU and shuts down the spark via the processor and try finding a wiring diagram??
SOURCE: 2003 hyundai santa fe car alarm
I had the same problem a while back. What I did was disconnect the battery for a minute and I havent had that problem since.
SOURCE: 2005 Hyundai XG350L Fuel Filter
Hi there,
If you can get under the car just head to the petrol tank and look for the lines running to and from the tank,
There should be several thin copper looking metal tubes running from the tank to the engine bay,
Generally somehwere along that line should be the fuel canister that should look almost the same as your new one,
Its then a simple process of unscrewing the old one and screwing in the new one, Be aware not to use any sort of flame light ie lighter when under there as fuel will run out when you remove the old one. If its not under ther then it will be mounted in the engine bayas before just follow those tubes.
You may need to turn the igition on and off a few times once installed to prime the lines if the car does not automatically do this.
If it still wont start try pumping the gas/accelerator once or twice,
Be carefull not to flood the car and you should be away.
Hope this helps
Cheers
Steve
SOURCE: Entering a 2003 Hyundai Tiburon with no remote.
I belive all you have to do is put the key in the ignition and turn it counter clockwise. Hopefully that works for you.
SOURCE: 2003 Hyundai Elantra - diable alarm
YES!... with various system operating difference. Disconnecting the alarm does not disable it.. it only silences the alarm. You will still need the Keyless Entry System Remote to RESET the alarm to start the vehicle.
2,595 views
Usually answered in minutes!
×