I just replaced the thermostat for 2004 chrysler pacifica 3.5 eng. but having trouble aling the thermostat inside the housing where the radiator house connect. i try it twice is still leaking any suggestiong. pleasse hellp
Pacifica, 2003-2005 Print Here is how to do it,if it does'nt fit right make sure you have the right thermostat. Fig. View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine
Removal & Installation
3.5L Engine
CAUTION
Never remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.
View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine
To install:
SOURCE: I need to replace the thermostat for a 2005 chrysler pacifica
Follow the Upper Radiator Hose to the Block. There is a Bell housing there that the Hose Connects to. Remove that Bellhousing and the Thermostat is Right Under it.
SOURCE: 2004 chrysler pacifica
It is for an oil change mainly and any other service your maintenance manual suggests at the mileage interval. It needs to be reset after each oil change to be accurate.
SOURCE: crankshaft position sensor location on 2004 chrystler pacifica
can u please tell me where on my 2004 chrysler pacifica is the crankshaft sensor located?
SOURCE: I would like to see a picture of a thermostat
Click over image for zoom...
Fig. Air bleed valve (1) and thermostat housing (2) 2.7L-engine
Hope this helps (remember to rate and comment this free answer).
2,330 views
Usually answered in minutes!
×