I need to replace tail or break lights on my 2007 dodge caliber and don't know how and what part numbers are. can you help me?
Popohead, if people thought it was easy, they wouldn't be here asking. Your reply is useless.
To remove the pins, look a them closely. Notice that there's two little notches cut into the cup that holds the pin. Use a flathead on each side to leveredge them out a little. If that doesn't work at all, you can use a pair of pliers to firmly grip the head of the pin and pull straight out. Quick firm pull.
Once the first pin comes out, the second pin should easily come out. At that point, firmly grip your taillight housing, and pull straight back: Don't try to wiggle it out, and don't try to lift it to one side or the other like a trunk or door. Just pull it firmly straight back like you would a dresser drawer.
Once it's out, the little wiring harnesses come out of the taillight housing with about a 1/4 turn, and the bulbs just slide straight out of those.
Good luck!
Just replaced the left rear turn signal lamp on my 2010 Caliber following Khabok's instructions. Thanks to his instructions the job was easy and took about 5 minutes, including the time it took to open the right side as well and swap bulbs.
Looking at the left bulb it didn't appear burned out so I swapped right for left to be sure.
Way to GO, Khabok!!
so it took me and my dad half an hour trying to figure it out... but i finally looked online and after i read Khaboks post it took me like 4 minutes :) thank you <3
Khabok you are the best. I just changed my 2008 tail light by myself and I'm a 50 year old lady.
i need to no .my airbay ligth stays on ,sometimes the ligths blink and radio no work
somebody hlep me tis a dodge caliber
×
The pins pull out the insert that holds the pins in pulls out also then carefully pull the lens out to get at the bulb it's actually pretty easy good luck and happy motoring.
8,416 views
Usually answered in minutes!
cant get the push pins out
need help getting the tail lights out have no clue
I'm trying to change the rear brake light bulb in my 2007 Dodge Caliber and cannot get the push pins out. Help!!!
I can not get the pins out neither....what to do?
Changed break caliber on 1994 mazda b4000 breaks won't bleed
Changed break caliber on 1994 mazda b4000 breaks won't bleed
×