I need to remove the radio from my 1994 Buick Century but i can not because there is 4 screws holding it in but i can only get to 2 of them which are on the left side the right side has a black casing over the screws that holds the buttons for rear defrost and the map light and i can not remove this casing to get to the screws
I need to remove the radio from my 1994 Buick Century but i can not because there is 4 screws holding it in but i can only get to 2 of them which are on the left side the right side has a black casing over the screws that holds the buttons for rear defrost and the map light and i can not remove this casing to get to the screws
I also need the answer to your Question. I can tell you there are of Phillips Screws and other screws that you use to remove the dash trim around the steering wheel then you have to take the piece under the steering wheel. You have to remove the 2 screws that holds Dionostic Plug-InI also need the answer to your Question. I can tell you there are of Phillips Screws and other screws that you use to remove the dash trim around the steering wheel then you have to take the piece under the steering wheel. You have to remove the 2 screws that holds Dionostic Plug-In
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Generally speaking, the module is mounted on the side of the block and the coils are mounted to the module. You can remove the entire assembly and then swap the coils over to the new module. There should be a wiring harness plugged into the end of the module.
this is a common problem and the dash cluster must be removed and sent out for repair, cost is about $175 to replace the LED (Light emitting diode) display that has burned out, this is a faxtory defect as far as this expert is concerned, it is not a fuse problem.
it has a digatal egr valve remove the egr valve and lean it with top engine cleaner from GM, with a tooth brush, then test the stepper motor with an ohm meter if it mesures more than 6 ohms replace it.
you should not have to remove the dash to install a new radio all you have to do is remove the trim around the radio and then take out the bolts that hold the radio in and remove the wires from the back and also if there is a Walmart or Radio Shack near you get an installation kit and you plug it from the plugs from your old radio and it is alot easier to wire it that way
I need to remove the radio from my 1994 Buick Century but i can not because there is 4 screws holding it in but i can only get to 2 of them which are on the left side the right side has a black casing over the screws that holds the buttons for rear defrost and the map light and i can not remove this casing to get to the screws
I also need the answer to your Question. I can tell you there are of Phillips Screws and other screws that you use to remove the dash trim around the steering wheel then you have to take the piece under the steering wheel. You have to remove the 2 screws that holds Dionostic Plug-In
×