Question about 2006 Chevrolet Express

1 Answer

How to change a cabin filter on a 2003 express 1500

Where is it located

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

My air pressure is low in 2003 Chevy express 3500 , I change the blower motor and still have the same problem ....the ones on the passenger side blows a little harder then the driver side I ready need to fix this problem cause it is hot in Texas

Posted on Sep 15, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 4 Answers

SOURCE: Cabin Air Filter Location

Empty glove box, remove axcess panel and the open the axcess door, two (2) filters inside,

Posted on Jan 11, 2009

Marc Podeszek

  • 840 Answers

SOURCE: Cabin air filter Location

cabin air filter is under the golve compartment or under the cowl vent cover / Please rate my response thank you very much

Posted on Feb 01, 2009

Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: Are there cabin filters on a 2003 Chevy Tahoe???

1 Tools needed are a Phillips screwdriver and a socket wrench. Open door to passenger side of vehicle. 2 Under the glove compartment is a kick plate cover held in place by four screws. Remove the screws and take off cover. 3 The door to the cabin filter is now visible. Remove screw in door and unhinge. 4 Remove the first filter by pulling straight down. Remove the second filter by sliding forward and pulling down. Replace with clean cabin filters. Reattach door and kick plate cover. 
Good luck and hope this helps.  

Posted on Jun 27, 2009

Nomodo4u

Poppy Chulo

  • 863 Answers

SOURCE: where is my cabin air filter located on my 2008

You should get instructions on where to put the air filter when you purchase new ones.  I think that it is under the dash on the passenger side.  There should be a cover underneath the glove box with screws holding it in place.  This thing takes two air filters so Chevy can milk more money out of you.

Posted on Oct 24, 2009

Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: trying to locate cabin air filter in 2003

The 2002/2003 Silverado was a change over year for Cabin Air filters. I know with the Chevy Avalanche the 03's did not have them and 02's did. The dash/center console changed with the 03's, and I believe it was done away with in that change over.... Still shows up on catalog, but the 03 has no Cabin Filter.

Good luck, and Merry Christmas

Posted on Dec 06, 2009

Testimonial: "That's excellent. Thanks heaps."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How many airbag sensors in a 2008 gmc acadia


1) Front End Sensor - Right--Located under the front hood in the engine compartment (2) I/P Air Bag--Located at the top right under the instrument panel (3) Roof Rail Air Bag - Right--Located under the headliner, extending from the passenger front windshield pillar to the passenger rear windshield pillar (4) Side Impact Sensor (SIS) - RF--Located under the right front door trim near the lower rear of the door frame (5) Sensing and Diagnostic Module (SDM)--Located underneath the vehicle carpet under the center console (6) Seat Belt Pretensioner - RF--Located under the trim near the bottom of the center pillar (7) Side Impact Sensor (SIS) - RR--Located under the right rear door trim near the lower rear of the door frame (8) Roof Rail Module - Right--Located behind the garnish molding on the upper rear pillar (9) Roof Rail Module - Left--Located behind garnish molding on the upper rear pillar (10) Side Impact Sensor (SIS) - LR--Located under the left rear door trim near the lower rear of the door frame (11) Seat Belt Pretensioner - LF--Located under the trim near the bottom of the center pillar (12) Side Impact Sensor (SIS) - LF--Located under the left front door trim near the lower rear of the door frame (13) Roof Rail Air Bag - Left--Located under the headliner, extending from the driver front windshield pillar to the driver rear windshield pillar (14) Steering Wheel Air Bag--Located on the steering wheel (15) Vehicle Battery--Located at the front left of the engine compartment. (16) Front End Sensor - Left--Located under the front hood in the engine compartment

Aug 12, 2015 | GMC Cars & Trucks

2 Answers

My car smoke while the engine is on


Turn it off. Dont lift the bonnet until its cooled down.
have patience and then pull up the bonnet to see where the problem is.

Jul 22, 2015 | 2007 Suzuki Forenza Sedan

3 Answers

Squealing noise in park


If youre just idiling, then it may just be the serpentine belt that needs to be replaced.

Mar 05, 2015 | 2004 Jeep Grand Cherokee

2 Answers

When driving sounds like an electric motor is running


Check power steering fluid and or tranny fluid.if low check for leaks.,., fix or repair.,., or just fill see if it stops. Do not over fill .,.? , get back to me

Apr 08, 2014 | 2008 Jeep Compass

1 Answer

O2 sensor bank 1 sensor 2 replacement instructions 2004 toyota tacoma v6


LOCATIONS There are different locations in the exhaust system where O2sensors are positioned. The locations have been given numbers and will be used in the accompanying charts to identify the positions of O2sensors in most vehicles. Due to mid-year production changes or factory inconsistencies, all models may not be covered. If a vehicle being serviced is not covered in the charts, inspect the exhaust system (while cold!) in the general locations to find the applicable O2sensors. NOTE: If equipped with dual exhaust systems, there may be up to 4 or 5 O2sensors in the exhaust system. Be sure to locate all of them before commencing with any testing or service. Fig. 1: Location No. 1 - down pipe 79248g01.gif
Fig. 2: Location No. 1 - typical O2sensor located in the exhaust manifold 79248g04.gif
Fig. 3: Location No. 2 - left and right banks of a V-type engine 79248g02.gif
Fig. 4: Location No. 3 - exhaust collector (where more than 1 pipe joins together) 79248g05.gif
Fig. 5: Location No. 4 - outlet of the catalytic converter 79248g06.gif
Fig. 6: Location No. 5 - inlet and outlet of the catalytic converter 79248g03.gif
93028c01.gif
93028c02.gif
prev.gif next.gif

Nov 12, 2010 | Toyota Tacoma Cars & Trucks

1 Answer

Where is the oil presure sending unit in an 1996 pontiac grand am manual 2.4 liters 4 cylynders.


Here's a copy of component locations for various engine sizes for the 1996 Pontiac Grand Am that I had on my online resource.prev.gif next.gif COMPONENT LOCATIONS The component locations shown are typical, and may vary slightly from one model year to another, because of variances in manufacturing and assembly. Fig. 2: 2.0L Engine Component Locations 91064gtt.gif
Fig. 3: 2.3L Engine Component Locations — 1988–90 91064gtu.gif
Fig. 4: 2.3L Engine Component Locations — 1991–93 91064gqa.gif
Fig. 5: 2.3L Engine Component Locations — 1994–95 91064gqb.gif
Fig. 6: 2.5L Engine Component Locations 91064gtw.gif
Fig. 7: 3.1L Engine Component Locations 91064gty.gif
Fig. 8: 3.3L Engine Component Locations 91064gtz.gif
prev.gif next.gif

Aug 29, 2010 | 1996 Pontiac Grand Am

1 Answer

How many oxygen sensors are in my 95 oldsmobile aurora? and where are they located?


LOCATIONS There are different locations in the exhaust system where O2S sensors are positioned. The locations have been given numbers and will be used in the accompanying charts to identify the positions of O2S sensors in most vehicles. Due to mid-year production changes or factory inconsistencies, all models may not be covered. If a vehicle being serviced is not covered in the charts, inspect the exhaust system (while cold!) in the general locations to find the applicable O2S sensors. NOTE: If equipped with dual exhaust systems, there may be up to 4 or 5 O2S sensors in the exhaust system. Be sure to locate all of them before commencing with any testing or service. Fig. 1: Location No. 1 — down pipe or exhaust manifold 79248g01.gif
Fig. 2: Location No. 1 — typical O2S sensor located in the exhaust manifold 79248g04.gif
Fig. 3: Location No. 2 — left and right banks of a V-type engine 79248g02.gif
Fig. 4: Location No. 3 — exhaust collector (where more than one pipe joins together) 79248g05.gif
Fig. 5: Location No. 4 — outlet of the catalytic converter 79248g06.gif
Fig. 6: Location No. 5 — inlet and outlet of the catalytic converter 79248g03.gif
93068c01.gif
prev.gif next.gif

Jul 03, 2010 | 1995 Oldsmobile Aurora

1 Answer

What color is the power wire in 1994 toyota pick up


this might help
1994 Toyota Pickup Car Security Wiring Diagram
Battery Constant 12v+ Positive Wire (+): White And White/Red
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness
Starter Positive Wire (+): Black
Starter Positive Wire Location: Ignition Switch Harness
Ignition Positive Wire (+): Black/Yellow
Ignition Positive Wire Location: Ignition Switch Harness
Second Ignition Positive Wire (+): Black/Yellow Or Black/Red
Second Ignition Positive Wire Location: Ignition Switch Harness
Accessory Positive Wire (+): Blue/Red
Accessory Positive Wire Location: Ignition Switch Harness
Parking Light Negative Wire (-): Red/Black
Parking Light Negative Wire Location: At Steering Column Harness
Parking Light Positive Wire (+): Green
Parking Light Positive Wire Location: In Drivers Kick Panel
Power Door Lock Negative Wire (-): Blue/White
Power Door Lock Negative Wire Location: At Door Control Relay. The door control relay, is located behind the driver dash speaker.
Power Door Unlock Negative Wire (-): Blue/Yellow
Power Door Unlock Negative Wire Location: At Door Control Relay. The door control relay, is located behind the driver dash speaker.
Door Trigger Negative Wire (-): Black/White Or Black
Door Trigger Negative Wire Location: At 2-Pin Plug, Top Of Fusebox
Domelight Supervision Wire: Use Door Trigger, Requires Relay
Domelight Supervision Wire Location: N/A
Horn Negative Wire (-): Green/Red
Horn Negative Wire Location: At Steering Column Harness
Tachometer Wire Negative Wire (-): Black
Tachometer Wire Negative Wire Location: At Diagnostic Connector. The diagnostic connector, is located on the passenger inner fender near the fuse/relay box.
Brake Light Positive Wire (+): Green/White
Brake Light Positive Wire Location: At Switch Above Brake Pedal
Factory Alarm Disarm Wire (-): N/A
Factory Alarm Disarm Wire Location: N/A
Factory Anti-Theft System: N/A
Factory Anti-Theft System Location: N/A

Nov 29, 2009 | 1994 Toyota Pickup

1 Answer

Need brake circuit diagram for 1991 chrysler new yorker


Hi,
1991 Chrysler New Yorker Auto Security Wiring Diagram
Battery Constant 12v+ Positive Wire (+): Red and Pink
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Yellow
Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Dark Blue
Ignition Positive Wire Location: Ignition Switch Harness

Accessory Positive Wire (+): Black/Orange
Accessory Positive Wire Location: Ignition Switch Harness

Parking Light Positive Wire (+): Black/Yellow
Parking Light Positive Wire Location: In Drivers Kick Panel

Power Door Lock Positive Wire (+): Orange/White Or Orange/Violet
Power Door Lock Positive Wire Location: In Drivers Kick Panel

Power Door Unlock Positive Wire (+): Pink/Violet
Power Door Unlock Positive Wire Location: In Drivers Kick Panel

Door Trigger Negative Wire (-): Yellow
Door Trigger Negative Wire Location: In Drivers Kick Panel

Dome light Supervision Wire: Use Door Trigger (Requires Relay)
Dome light Supervision Wire Location: N/A

Trunk Release Positive Wire (+): Black/White (Requires Relay)
Trunk Release Positive Wire Location: At Trunk Release Switch

Horn Negative Wire (-): Black/Red
Horn Negative Wire Location: At Relay In Fuse box

Tachometer Wire Negative Wire (-): Black/Gray
Tachometer Wire Negative Wire Location: At Ignition Coil

Brake Light Positive Wire (+): White
Brake Light Positive Wire Location: At Switch above Brake Pedal

Factory Alarm Disarm Wire (-): Light Green/Orange
Factory Alarm Disarm Wire Location: In Drivers Kick Panel

Factory Anti-Theft System: N/A
Factory Anti-Theft System Location: N/A


Thank You for contacting Fixya.com

Aug 03, 2009 | 1991 Chrysler New Yorker

Not finding what you are looking for?
2006 Chevrolet Express Logo

3,040 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...