Key is stuck in ignition
SOURCE: 1988 Wrangler Ignition Switch Removal
There are four (sometimes two) bolts that hold the steering column to the dash. remove them & column will come down to let you get in there.
follow instruction sheet with switch. if you don't get it centered correctly it wont work correctly.
SOURCE: Removing doors from Jeep Wrangler - Dome Light Stays On
I have a 97, and my fuse for that is behind the glovebox. Open the box, slide the end of the strap to disconnect it, then remove the box. The fuse is marked. Something like "Dome lt. elim." I think it's located one up from the bottom right. This can actually be done without removing the glove box. For a more permanent fix, quadratec.com has a switch that plugs into the fuse location and mounts under the dash, so you can just flip the switch. Hope this helps.
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Testimonial: "Will try! Thanks!"
SOURCE: The key on my Jeep Wrangler will not turn so that
could be, try moving wheel right to left while trying to turn the key, steering wheel may have tension on lock, if that doesnt work try another key if still nothing then replace switch, remove cover around switch, then use a pick to push in lock pin must trun key to get pin to go in you will see little hole on housing were lock is that where you install pick and push while truning key, got to get key to turn once more to get that lock out.
SOURCE: 2000 jeep wrangler will not start from the key
It sounds like you have a bad neutral safety switch or your linkage is worn enough that it's not registering properly.
799 views
Usually answered in minutes!
×