SOURCE: torque on a 2000 dodge neon spindle nut
If you are looking for the spec on the large nut for the CV axle to hub it is 180 ftlbs
SOURCE: Replaced rear axle pinion bearing and seal, need
There is no torque specs,this nut has to be tightened back like it was ,the best thing to do,was,to late now,is to use a torque wrench to remove the nut,and remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pion bearing ,and the rear pinion bearing,and it has to be crushed to a certain amount,to aquire deepness into the ring gear,anyway just give it about 25 lbs torque,any more the crush sleeve will crush even more and the deepness of the pinion will be too much.
3,653 views
Usually answered in minutes!
×