Have you checked the fuel cutoff switch?
Fig. Fig. 1: The inertia switch reset button is located on the top of the switch
GENERAL INFORMATION
This switch shuts off the fuel pump in the event of a collision. Once the switch has been tripped, it must be reset manually in order to start the engine.
The inertia switch is located on the driver's side of the vehicle behind the kick panel near the driver's feet.
RESETTING THE SWITCH
See Figure 1
REMOVAL & INSTALLATION
To install:
Testimonial: "Thank you "
SOURCE: 1999 ford contour fuel pump removal
YOU will need the car on a hoist, doing it on the ground is almost impossiable, disconnect the filler neck at top, remove the straps, lower tank slow and disconnect wiring and fuel hoses, you need a special tool to remove the gas line retainer clips.
SOURCE: Location of the fuel pump relay switch 1985 Ford F150
Its under the hood drivers side on the upper firewall.
SOURCE: no power to fuel pump or fuel pump wiring harness...
try the electrical ignition switch on the steering wheel colum
SOURCE: replacing a fuel pump on a Ford Contour
Fuel Pump Module —Vehicles with Returnless Fuel System
Special Tool(s)
Wrench, Sender Unit, Fuel Tank
310-065A (23-054)
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
SOURCE: have ford f 150 302
i got a 6 cylinder ford truck when i drive it with the first tank it loose power. then i push the second tank and it runs normal .
769 views
Usually answered in minutes!
Also replaced crankshaft position sensor
Fuses check out all good
×