Performed self test...ok when i press ON it dashboard light does not come on. However, when i press ON and RES the light comes on. checked both fuses
SOURCE: cruise control won't work
Does the on light in the dash come on? If not, you may have a broken switch in the steering wheel which is a fairly cheap repair. Otherwise, the controls work through the Printed Circuit Board in your dash (your instrument cluster) and the problem could be as simple as a solder defect or faulty component. The problem is that no Ford Service Technician that I know will touch this and tell you that you need to replace it.
The instrument cluster is very easy to replace but may cost you a few more dollars than you want to spend. I would have someone with an electrical background check the cruise control switches in your steering wheel with a multimeter before going any further with this. Also check the wiring for resistance leading from the switch to the cluster.
SOURCE: 2002 Ford F150. Cruise control stopped working.
Did you have the recall done on it ?
recall 05S28. Description: Speed Control Deactivation Switch.
It could be a blow fuse in the recall harness, if you did have it done.
Try the self test, and see what the results are. If you do not get it into self test mode, it could be the fuse in teh recall harness that is blown. The 1st revision of the recall harness was an inline ATM fuse, not sure if the revision 2 was the same. If that fuse is blown, the switch is leaking, and should be checked.
Self-Test Diagnostics
WARNING:
This test is a key on engine off (KOEO) test only that is conducted in park only with emergency brake fully engaged.
1. Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo. Release the OFF switch.
2. Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL.
If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch.
Note:
There will be a slight delay when the last button is pressed and the lamp flashes.
3. A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective.
If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
— 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
SOURCE: 2003 expedition cruise control inoperative
I had this same Problem and it was a simple vaccuum hose leak connected to the cruise control module. Try replacing this small hose.
SOURCE: cruise control
The cruise control should have a fuse in the interior fuse block, and a larger fuse and/or relay under hood in the relay center block. Test them with an automotive test light (You can purchase these for anywhere from $5.00 to $50.00 depending on the quality you want and the place of purchase).
If you find a bad fuse or primary fuse, obviously those need to be replaced. Relays can't be tested readily using the light. Unfortunately the simplest method for finding out if a relay is bad is to replace it. The relay for that cruise runs between $15.00 to $20.00 depending where you purchase.
Let me know how it goes and we'll see what more we can do!
SOURCE: 2003 expedition cruise control inoperative no
I'm having the same issue with mine. Just checked both fuses #5 and #12 under the dash, but both are fine. Can't find Relay #302 for the speed servo. 2003's aren't listed in the recall. Ugh!
3,501 views
Usually answered in minutes!
how do I get to the screws to replace the cruise control switch in 2005 ford focus
×