SOURCE: 2006 chevy hhr transmission fluid and filter change
usually a pan under the trans. anywhere from 10 to 22 bolts. filter inside. some vehicles have an oil style filter on the externally, but i don't think that this is one.
SOURCE: turn signal relay switch, 94 s10 chevy blazer
The Turn signal relay on a 94 s10 blazer is located under the cluster area right behind the panel that holds the parking brake release handle you will see it once a couple of trim panels get remove it will be to the right side of the brake release handle
SOURCE: 2006 Chevrolet HHR LT Problem
After searching around, I found several posts that suggested reseating all the relays and fuses under the hood. After checking, I noticed nearly all of them were not seated well. I pushed them all down and I haven't had the problem since.
Ken
SOURCE: service engine soon light came on.
That is an EVAP code. its a vent control code. you can manually test it by powering it up if you know where its at. i cant remember exaclty where its at off the top of my head but its only 2 wires. using a volt meter you want to make sure power is getting to it, but you cannot activate it without dealer scan tool.hmmm if you can figure out which is ground and power when you give it 12 volts it should click. meaning your vent solenoid works and you have wiring problems or its leaking.
EVAP problems are hard to finde with out scanners. you can change the vent solenoid and hope it fixes it. but a code points you to the direction of a problem. hopefull its not wiring problems. in the northern states with snow. ice can pull out wires and also get clogged in the vent solenoid and lock it up. its either wiring or bad or a leaking solenoid. check condition of wires. if they look good try a vent soleniod.
if that doesnt fix it after a engine light reset and 2 weeks or so. then goto dealer. you need to reset it after repair. light will not go off on its own.GOOD LUCK
Michael
ASE certified.
plz rate
SOURCE: 2006 hhr has code for cam sensor/diff module? will
Stand in fromnt of the car, the cam shaft position module is located on the front of the engine to the right hand side just below the fuel rail.
140 views
Usually answered in minutes!
×