My alarm would set off when I tried to start my car and I found in another forum that I had to set it to "On" until the alarm stopped sounding. Then turn the key to off, wait 30 seconds, and then start the car and it would disarm the alarm and my car would start. Which it did. What I want to know is why did my alarm malfunction and why does this work to disarm it?
SOURCE: 2003 hyundai tiburon alarm system
factory fitted alarm?? no way its done through the ECU and shuts down the spark via the processor and try finding a wiring diagram??
SOURCE: 2003 hyundai santa fe car alarm
I had the same problem a while back. What I did was disconnect the battery for a minute and I havent had that problem since.
SOURCE: Entering a 2003 Hyundai Tiburon with no remote.
I belive all you have to do is put the key in the ignition and turn it counter clockwise. Hopefully that works for you.
SOURCE: 2003 Tiburon Timing Belt Replacement
the timing belt is not due to be changed until 120,000 miles i cant promise but you could make it to 150,000 but i wouldnt go much farther then that unless it wasnt changed at 60,000 if that is the case you are on barrowed time you need the belt changed as soon as possible.
SOURCE: program factory remote keyless entry for 2003 Hyundai XG350
This bulletin supersedes TSB# 02-90-001.
DESCRIPTION:
The security system keyless adapter cable (SPX/Kent-Moore P/N 09900-21300) is a special service tool (SST) that is used for programming new keyless entry remote transmitters to the factory security systems. The keyless adapter is used in conjunction with the Hi-Scan Pro (with Hi-Scan SOL Pro Software Version 09-29-03
or newer) and Data Link Connector (DLC) Cable.
SERVICE INFORMATION:
The keyless adapter cable can be used on the following vehicles:
NOTE
SHOP MANUAL
PAGES
2004 MY Elantra
BE-73 - BE-74
2004 MY Santa Fe
BE-43 - BE-44
2004 MY Sonata
BE-40 - BE-41
2004 MY XG350
BE-46 - BE-47
KEYLESS ADAPTER CABLE INSTRUCTIONS:
and press ENTER
.
NOTE
"Release date 29. Sep. 2003" OR LATER
must appear on this screen. To update your SOL card with the latest software go to www.hmaservice.com and refer to TSB 00-00-001.
and press ENTER
.
.
and press ENTER
.
on the Hi-Scan Pro and verify that the remote(s) are functioning properly.
and disconnect the adapter cable from the multi-purpose connector.
593 views
Usually answered in minutes!
×