My 2004 Hyundai Santa fe started slowing down on me on my way to work then stalled the oil light had come on when I was on my way to work I figered ide take care of it in the morning after it stalled I put in four quarts and it started to turn over but when I tried putting it in drive it stalled again what should I do?

SOURCE: 2003 santa fe

It needs a new pruge valve. The purge valve is sticking open allowing fuel vapors into the intake manifold causing a rich hard start condition.

SOURCE: oil filter location on 2004 hyundai santa fe

Hi. If your are faceing the front of the car it will be on your left side at the bottom. You will have to get under the car to see it and if you have a skid plate i has to come down first.

SOURCE: Fog Light Replacement Hyundai Santa Fe

The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

Ed

• 479 Answers
• Posted on Apr 21, 2009

SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe

If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.

Hope this is of some help.
Ed

SOURCE: how to change spark plugs on hyundai 2004 2.4L

Remove the plastic cover that goes over the engine (the one with the Hyundai logo).
At this point, you will see the cables that goe to each fo the spark plugs.
Noting their position, remove them.
The spark plugs are ready to be removed, turn counterclockwise and replace with manufacturer recomended ones.