I need to change my high beam bulbs out and I noticed hoe terribly cloudy my headlight covers are can I clean them or should I replace them?
SOURCE: Low beams do not work but High beams do
you have to change just the low beam bulb. Ive already changed mine twice in my 06.
SOURCE: 2002 acura tl headlight issue
MAKE SHURE YOUR GROUNDED AND THE BULB IS IN RIGHT SOME BULBS YOU CAN NOT TOUCH WITH YOUR FINGERS BECAUSE OF MISTURE ON SKIN
SOURCE: High beam works, headlight doesn't, fuse & bulb are ok
replace the bulb AGAIN...most likely bulb was bad from the get go.
SOURCE: high beam headlight does not work properly
it more then likey a lose wire or bear one. run the line down. i think that the high beams run on diff. fuses. you can try that!
SOURCE: passenger side headlight only works on high beam.
If you put it in; did you touch the bulb with your fingers? If so, I've seen bulbs pop as soon as they're put in. The oil from your skin leaves a residue, and the heat goes to it, and blows the bulb. wear jersey or latex gloves when you re-install new bulb. If it still doesn't work, replace headlight bulb socket
384 views
Usually answered in minutes!
×