I need a diagram to reconnect vacuum lines on a 1998 Grand Caravan 3.3 L V6
Hi there:
I suggest check this image about engine vacuum diagram for the 3.3L and 3.8L engines - 1997-99...
Hope this helps; also keep in mind that your feedback is important
and I`ll appreciate your time and consideration if you leave some
testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
SOURCE: I need a diagram for a 1994 dodge grand caravan se
Try this
Testimonial: "you did find the diagram that works, thanks."
SOURCE: belt diagram 4 1998 dodge grand caravan
My sincere apologies for the delayed response.
I am personally going back to answer - unanswered questions.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
Thanks!
http://www.2carpros.com/car_repair_information/year/1998/make/dodge/model/grand_caravan/1998_dodge_grand_caravan_drive_belt_routing_diagram.htm
SOURCE: firing order of 2003 dodge grand caravan
For the 2003 Dodge Caravan (and Grand Caravan) ALL 3.3L V6 Engines (including the Flex Fuel): Also for 3.8L V6 Engines:
Firing Order:
1-2-3-4-5-6
Cylinders:
........(back).......
|...1....3....5...|
______________
|...2....4....6...|
Ignition Coil:
.......(back)
electrical connection
...........|
..........V
5........1........3
2........4........6
.......(front)
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
5,010 views
Usually answered in minutes!
×