Drivers side window off track
1
Open the door, place the blade of the screwdriver behind the lock switch on the door panel and pop it out of the door panel. Repeat this process for the trim panel around the power window switches and the interior door handle, pulling both of those pieces off of the door.
2
Unbolt the door panel from the door using the 3/8-inch ratchet and socket. There are bolts behind the door lock and in the corners of the panel. If this is a front-door panel, pull off the triangular panel that covers the mirror bolts using your hands. Then lift the door panel up towards the top of the door, and then pull it off the door.
3
Plug in the window switches again to the harness on the door. Roll the window down halfway until you can see the bolts that clamp the window in place through the access holes. There are two 10mm bolts that clamp the window to the window track, and there are access holes that allow you to unbolt those clamps using a 3/8-inch ratchet and socket. Unbolt the clamps at this point
.4
Pull up the rear of the window--the section toward the back of the Tahoe--and tilt the window up so that it is oriented perpendicular to its normal position. Pull the window out of the door panel, tilting it in towards the interior of the vehicle.
5
Slide the replacement window in place in the same manner you pulled out the stock window. Tilt the window back into the clamps, then loosely tighten the clamps in place. Roll the window up and down a few times to make sure it fits correctly, then tighten down the clamps on the window using the 3/8-inch ratchet and socket.
6
Reassemble the door panel in the reverse order of dis assembly.
Custom Wheels For Mustang
SOURCE: driver side window off track
2 sets (total 4) T30 Torx screws need to be removed.
The 2 holding the interior door handle grip / cup.
And then behind where the cup is, there are 2 more, that secure the door panel to the door.
FWIW, there are also 2 philips screws. One at the top, near the mirror. The second at the moveable door handle latch.
Lastly, of course, the standard "pop" sort of fasteners, around the perimeter on the 2 sides and bottom of the door panel. Also, there are 2 light blue plastic alignment posts (that do *not* fasten).
When re-assembling, make *sure* to properly catch / engage the door panel's top black plastic lip into the 3 hidden metal "U" holders, at the very top of the door panel.
SOURCE: driver side power seat 2001 Chevy Tahoe
as long as nothing is stuck in track and you hear no noise when using switches, look for broken wire at connector or in harness. ck fuse first of course, if blown, something may be stuck in track causing it to stop and blowing fuse
SOURCE: 2003 Chevy Tahoe. Driver's side power window
check releys and wires in door jam 1 might be broken failing that u need a new switch
SOURCE: 2007 chevy tahoe driver side door handle will not open door
the linkage behind the handle either the retaining clip broke or popped off need to remove the door panel to check and fix
Testimonial: "Thanks I thought it might be a cable or linkage. Much thanks"
718 views
Usually answered in minutes!
×