- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If all bolts and door handles have been removed the panel is now held in place with clips. Carefully go around it and using a flat bladed screw driver pry it off.
? 2:58
www.youtube.com/watch?v=MrLvBJRKt7g
Jul 8, 2011 - Uploaded by CircleofCycles
2008 AUDI Q7 Fond Du Lac, WI Stock #B2059 866-606-9906 http://www. ... 4.2 LITER V8 ENGINE, FACTORY NAVIGATION SYSTEM WITH NAV DISC ... 2015 Audi Q7 S Line 3.0T Quattro Tiptronic Full Review / Exhaust/ Start ...
On the inside trim,
you can remove screws (these screws may be covered by filler pieces or
may be visible, or they may require you pry a plastic piece off that
covers the screws) that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can disconnect the linkage connecting to the outer handle and remove the bolts securing the outer handle on
Ok Remove plastic plug on the inside of door there is 10 mm hole use a hooked pick set pick put through the hole and pull the plastic cir clip towards the back of the door that will release the smaller part of the outer handle then the handle itself can be taken out.this is so simple but so deceiving the actual cir clip is hard to notice because of all the plastic **** on the inside backing plate the cir clip is just on the inside of hole look hard it is 2mm thick & 20mm high (black plastic) place point of pick in between backing plate & cir clip hook it and pull back the front door is based on the same principle but is a lot easier
You need to use a small hook. Push it into the hole on the inside of the door where the round bung is.
Push forward on the plastic so it moves towards the front of the car then turn the hook towards you and pull back it shoould move a slide so you can remove the handle extension, you dont have to remove the colour coded cover from the outside.
Hope this helps.
×