SOURCE: 1998 dodge 1500 wont shift
first of all standard or auto i am guessing its standed standard under drivers side hood near master cylinder there is a small clutch reservoir if there isnt enough fluid it wont extend the throw out bearing far enough for a shift because the clutch pedal is hitting the floor not enough fluid to extend the slave cylinder to drive the fork second faulty slave cylinder or throw out bearing as far as the light blown dash bulb or somone snipped the wire or took the bulb out
SOURCE: 99 dodge ram 1500 4x4. dosen't want to shift from
Scan your computer and check voltage at your T.P.S (Throttle Position Sensor) should have 0.50 volts with key on engine off, also press on gas paddle should increase up to 5.0 volts, there should not be a break in voltage as you press paddle, if it drop while pressing gas paddle bad sensor, computer don't know how far on the gas your foot is at.Good luck.
SOURCE: my 97 dodge ram 5.9L does not shift into od it
If this is a 5.9 diesel Clean all the battery terminals, especially clean all the wires on the drivers side battery. Give me feedback if this helps
119 views
Usually answered in minutes!
×