Hub assembly diagram - 1998 Dodge Ram 1500 4WD

for what vehicle

Hi. What rear axel type do you have? Is it a 1975 beetle hub?

Go to you tube and ask for "How to replace Dodge Dakota front hub", you will find 2 or 3 good videos about it, I follow these videos and change mine in about 3 hours, note that I never did it in any car or truck. Another tip is that all videos I found was about 4x4 Dakotas and mine is 4x2, the only difference is the hub center fix, 28 mm screw on 4x2 and 32 mm nut on 4x4.

We have no such diagrams. You will need to try and find a used factory service manual. ebay is a good source.

For front wheel assembly diagram and replacement,click the link below and go through procedure:----Front wheel hub assembly Diagram and replacing procedure? http://howtobyme.blogspot.in/2012/02/front-wheel-hub-assembly-diagram-and.html
----------Front wheel assembly diagram to replace wheel bearing? http://howtobyme.blogspot.in/2012/02/front-wheel-assembly-diagram-to-replace.html
-------------How to replace Front wheel bearing? http://howtobyme.blogspot.in/2012/02/how-to-replace-front-wheel-bearing.html
-----------Check all 3 links one by one.This will help.Thanks.

Removal & Installation Front To Remove:
The front wheel bearings are not serviced separately. If the front wheel bearings are defective, the hub and bearing assembly must be replaced.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Lubricate the threads on the halfshaft with clean engine oil.
3. Remove or disconnect the following:
   • Front wheels
   • Halfshaft hub nut
   • Caliper from the steering knuckle WARNING
     DO NOT allow the brake hose to support the weight of the caliper.
     
   • Brake rotor
   • Anti-lock Brake System (ABS) sensor from the backing plate
   • Hub and bearing assembly from the backing plate
   • Hub and bearing assembly from the halfshaft
   • Hub and bearing assembly

To Install:
Exploded view of the front hub mounting and related components

1. Install or connect the following:
   • Hub and bearing assembly onto the halfshaft
   • Hub and bearing assembly to the backing plate. Torque the 3 bolts alternately and evenly to 70 ft. lbs. (95 Nm).
   • ABS sensor
   • Brake rotor
   • Caliper on the steering knuckle.
   • Halfshaft nut. Torque it to 118 ft. lbs. (160 Nm).
   • Front wheel. Torque the nuts to 100 ft. lbs. (140 Nm).

go to google type in mitsubishi endeavor hub assembly mr58918 diagram.

http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?categoryDisplayName=Drivetrain&fromType=parts&fromString=search&parentId=12-0&currentPage=1&filterByKeyWord=hub+assembly&isSearchByPartNumber=false&navValue=11200894&categoryNValue=11299999&fromWhere=&itemId=894-0&displayName=Wheel+Bearing/Hub+Assembly-Front&searchText=hub+assembly

these links are to remove but assembly is reversed
Here is a writeup on removing 5-bolt auto hubs

http://danielphotography.us/bronco/manualhubs/

Here is a writeup on removing 3-bolt auto hubs

http://www.superford.org/vehicles/re...d=3749&s=14884

Here is a writeup on removing manual hubs

http://fullsizebronco.com/forum/showthread.php?t=5450