Make sure you have your radio code if needed otherwise the radio won't work after this. Disconect battry, Unbolt main wire from starter, disconect switch wire from starter, unbolt starter, remove starter, fit new starter, connect switch wire, connect main wire to starter, connect battrey, start a couple of times to make sure all ok, input radio code.
SOURCE: replacing starter on 1988 toyota corolla
should be on the back of the engine block going into the transmission somewhere you may need to get under the car to access it good luck please rate -jeff
SOURCE: How to replace a starter on a toyota solara v6
You take out the battery, and the air-filter housing to give extra working space.
Then push in the starter motor to its place, and hand-tighten all its bolts.
Wrench tighten the starter bolts to the engine 38.ft-lb
Connect the solenoid wire, and tighten to 10.ft-lb
Connect the battery positive cable, and tighten to13.ft-lb.
Replace the air-filter housing.
Replace the battery, and terminals.
Crank-up the car.
SOURCE: 1999 Toyota Corolla interior door handle
There's two screws by the handle, pull those out and you'll see how it all connects on the inside. I was able to remove my broken one, and drill a hole into the plastic where it broke and reuse it - it's lasted over 4 years now.
SOURCE: Toyota 1999 Corolla,low idle,my corolla idles at
adjust the accelerator cable.
Testimonial: "i thought the idle was ecu controlled,but i see what your saying,ajust cable stop.ie allen screw with locknut to bring up revs.thanks"
SOURCE: Belt routing diagram for1999 Toyota Corolla
Thats a 98 belt routing same engine. 99 wouldnt load
618 views
Usually answered in minutes!
×