Need to take off the rear door panel
You will need to remove the door panel in order to
prevent further damage to the electric window motor in
your door. Electric window motors are typically very
expensive so you should be careful not to damage it. You
should be able to easily remove the roller blinds once
the door panel is removed.
____________________
BMW scanner 1.4.0
SOURCE: Can't figure how to remove right rear door panel on 2001 Pontiac
These are bad about those Cable operated window devices .. If it is bad get on ebay and get one ordered its your best bet.. Just take a flat screwdriver and go around the bottom of the door panel and pop it loose and up the sides .. there might be a hidden screw or two in the middle around the handles.. good luck ..
SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora
The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.
Good luck
SOURCE: window dropped into rear door panel. How do I remove the panel & repair
the window regulator has failed. the door panel has to be removed first which requires removing the trim piece that is on the grab handle (extremely hard to remove without breaking) there are three of four screws that hold the door panel on. once the door panel is off, the vapor barrier has to be removed. don't tear it, it is there for a reason to keep water out of the vehicle. make sure you reseal it properly with window weld. once the vapor barrier is removed you will need to unclip the window glass from the regulator. i typically will take and break the tab that holds the window. once the window is loose, move the glass all the way to the top of the door. now remove the regulator, swap the motor over, and reassembly. i would recommend taking the vehicle to a bmw dealership, around $650 for the complete repair and the dealership will stand behind their repairs
SOURCE: Right rear window is off the tracks. How do I remove the panel?
if the window is off track the regulator is probably bad. to remove the door panel should be a couple of screws by the inside pull handle and possibly one by the door handle itself also check the bottom of the door for any then just pull it off and lift up to clear latches and remove plastic film to get to inside of the door
SOURCE: how do i remove rear inner door panel on my Peugeot 407
should be screws behind rear door handle u have to take cover of screws will be behind u also need to remove the winder 4 window if manual and not electric the panel itself will be held on with poppers just grab bottom of panel and pull hard then work yuor way up sides once you have unclicked poppers from bottom and side of panel grab panel and push upwards as most weather strips are attached to the panel .
289 views
Usually answered in minutes!
×