Question about 1994 Chevrolet S-10

1 Answer

S10 blazer surges

On cranking, engine revs high and check engine light comes on. after restarting, it will generally idle correctly and check engine light is not on. while driving, the automatic transmission seems to shift into a lower gear repeatedly causing a surging feeling.

Posted by on

  • hmcguir Dec 07, 2008

    we already took intake back off and found nothing wrong. we tried propane around intake as well . The computer codes keep pulling up throttle position sensor.Its been replaced and show correct voltage. The computer still brings the tps back up.

    Sometimes it runs fine.

  • Anonymous Mar 31, 2014

    surge in lower gear change

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Might wanna check intake gasket for leaks on the high engine rev as for tranny might be in the comp

Posted on Dec 07, 2008

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Toyota Corolla Long crank with cold engine normal start and operation after warm engine


hi, i would like to advice you check the electronic idle speed control valve and also check engine coolant temp sensor. The ISC (idle speed control valve) is located somewhere below the throttle valve. the engine coolant temp sensor is located near distributor. it has a two wire connection. the sensor connector is usually green

Oct 25, 2017 | Toyota Cars & Trucks

1 Answer

2000 Toyota coaster it is a EFI.1HDE-FTE engine. While trottling it is fine but if I press the gas pedal and let go, the rev doesn't come down,it stays high, just keep a high rev,what could that be?


Do you have a check engine light on? Are you saying that the engine idle speed is excessively high? If that is the case have you checked for intake manifold vacuum leaks?

Jun 07, 2016 | Toyota Cars & Trucks

1 Answer

Why won't it rev?


1997 GMC Jimmy 4.3 L Vortec - Discussion on Topix

www.topix.com > General Motors
Aug 17, 2009 - I have a 1994 S10 Blazer with 4.3 Vortec. ... Sometimes runs fine, or it barely moves and won't get out of it's own way all the .... Can rev up, dies. 1994 Silverado 5.7L TBI Engine Missing/Surging/Sputtering ...
Sep 27, 2013
2001 Jimmy transmission not shifting
Jul 5, 2009
More results from www.topix.com

Jan 04, 2016 | 1994 GMC Jimmy

1 Answer

1996 S10 Blazer revs up and down and idles high. Stalls when smash on the gas? whats the problem


Idle air control motor. On the side of the throttle body. Either real dirty or bad.

Aug 06, 2014 | 1996 Chevrolet Blazer

1 Answer

Bmw316i oil light comes on while idlingand goes off when revs are higher


In general terms, the problem could be a faulty oil pressure switch, or you could actually have low oil pressure. You can verify which issue you have by checking oil pressure with a mechanical gauge or by replacing the switch.

Mar 12, 2014 | Cars & Trucks

1 Answer

1990 Buick Park Ave.


clean the idler on the intake and also clean the throttle sensor, it would also be best to change the air filter and clean the maf sensor. Idler does more than just idle vehicle it controls low revs, and drop down from reves. throttle sensor tell ecu what air to add to the fuel. and the MAF tells ecu how much air is coming into the intake. also check for broken cracked vacuum lines.

Jul 17, 2017 | Cars & Trucks

1 Answer

1989 cevrolet s10 4 cylinder 2.5 engine idles idles to high for to long when first started


check the setting on the automatic choke . loosen the 3 screws on the mounting ring and turn the cap a few points to allow the choke to come off earlier.. If it is heated by pipes from the manifold ensure that the hot air is getting to the choke operating bi-metal spring. If electric ensure that the current is getting to the heater in the cap.

Dec 18, 2013 | 1994 Chevrolet S-10 Blazer

2 Answers

97 Chevrolet blazer, have code ignition coil 1-4 control. Circuit high input. Has detected open or short circuit. It misses more at low are idle speeds. When first cranked in morning. Cranks ok,after...


My personal suggestion would be to go for these repair catalogs. I know this website reliable-store that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.

Feb 09, 2018 | 1997 Chevrolet Blazer

Not finding what you are looking for?
1994 Chevrolet S-10 Logo

508 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...