No biggie Brother. Just the neutral safety switch needs be adjusted better. I've the same problem with my Ranger and I plan on just connecting the two wires together at the neutral safety switch. Then it will crank every time, no matter what gear it's in. but it's only natural to have it park when stopped anyway, so I see no problem in just jumping the 2 wires together to have the circuit always complete. It won't hurt a thing.
SOURCE: chevy tracker 4 cyl 4wd 2003
Most major auto part chain stores have a loaner code scanner (they require you to leave your ID while you use the tool in their parking lot). There is a connector under the dash near on the drivers side that accepts the reader....check the codes and Google them for repair info or post them back here.
SOURCE: 1996 chevy tahoe 4wd LT 4Door 5.7L Vortec. Truck
i suggest removing the flywheel inspection cover, and rolling the engine over a little bit at a time, checking to make sure that there are no worn or broken teeth. also, make sure there is no lateral movement, which could indicate a broken flexplate. good luck.
SOURCE: my 2001 chevy lumina will not start. it has the
if you have the chip in the key, then this will surely help you: http://newrockies.com/vatsbypass . It was the only thing that saved my car.
SOURCE: 2008 chevy malibu will not start sometimes
I have same problem with Malibu 2003,use the remote to lock the car then unlock it and start the car again.if this won't work probably it's the theft alarm stopping the engine from starting
65 views
Usually answered in minutes!
wires are tight on starter, thereis no signs of oil on the starter and it shows no codes
×