The ABS light on dash is on - scanner shows an ABS comouter module problem but the breaklight also blows frequentyl so was wondering if there is any relationship between the ABS going on and the break light not working. I have replaced the right rear breaklight a couple of times and think it must be an electrical problem. I want to eliminate all possibilities before getting a new ABS computer module
No no relationship. The abs light can come on for a lot of reasons (Sensor, non abs disc fitted (should be on all the time), plug connections, broken wire in harness, ABS module etc... But the module is a common problem. They normaly get a dry joint inside. My sugestion would be test the sensors at the module plug. I know which pins on an AU but unsure if same. If you decide to replace module & it fixes it pull the cover off the old module & look inside for a dry solder joint (broken or missing solder) can work sometimes & not others causeing intermitent fault. If found just pop some solder on it and keep it for a spare.
SOURCE: 1997 f150 flairside right rear break and turn signal light
Try pulling out your tail light then following your wires. you should have four going into the socket one for running light, brake light, and turn, follow those down. till you find where they go and if they keep going then those are not your ground. go back to the socket and take that last wire that runs down follow it till you get to the spot that it is grounded to and some times it will be grounded in with your license plate lights. if not directly to the frame
SOURCE: I have bleed rear breaks.I
I'm confused, how did U bleed the rear brakes and there's no fluid to them? first of all U need to get fluid to the rear.
SOURCE: 06 T & C replaced left rear speed sensor and
you need to check for voltage to sensor from module or a broken wire,also with a multi meter check for resistance from sensor from turning wheel
SOURCE: i have a 92 lumina euro i have no rear breaklights
yOU WILL HAVE TO PLACE THE sWITCH IN THE STEARING COLUME IT COST ABOUT 90 DOLLARS.
SOURCE: ba falcon heater
Just had the same thing happen to my BA. No hot air. I'm a bit of a handyman so I had a go myself. 8 Hours is a reasonable estimate. You have to remove the steering column and entire dashboard to get the bugger out. Not a job I would attempt again.
294 views
Usually answered in minutes!
×