I bought a blower motor relay but I'm sure where it's located to replaced.
Blower Motor Resistor Replacement
Removal Procedure
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
Tighten the screws to 1.6 N·m (14 lb in).
It is under dash on passenger side rt next to the blower motor. Be sure to check the harnes as these burn up as well you can get the plug from dealer and splice in if it is melted looking
SOURCE: front blower motor will not
This may be a faulty Blower motor resistor, usually mounted inside the blower motor air box, or defective blower motor. There is no single Relay for the blower motor.
770 views
Usually answered in minutes!
×