Just replaced fuel pump and have no power to pump
SOURCE: 1996 Gmc Jimmy Acceleration
check our egr valve if vale open to fast to mush air create hesitation disconnect the egr and try it out when accelerating egr valve open to put extra air in engine to burn polution bad valve create hesitation engine noise hope it FIXYA our problem thanks pierre
SOURCE: How do I remove the rear axle to replace the seal 1996 jimmy
You will have to remove the differential cover on the rear end, in the center of the gear cluster you'll have to rotate your axle until it exposes the ends of the axle shafts, push in the axles as far as you can from the brake pad assembly area, then, there this a C clips that slips into a groove on the end of the axle, you'll have to reove the C clip to pull out the axle.
SOURCE: fuel pump reset
for the most part its in the back in side the lift gate on the left or right side behind a small panel try this website to see if they have any information on your truck www.alldatadiy.com if you do not have an owner manual try this website to see if you can down load one for your truck its www.edmunds.com
SOURCE: 2000 GMC Jimmy won't start
i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ
549 views
Usually answered in minutes!
×