My car stalled out on me the other day so I checked the fuel connection to the injector and was getting gas to it so I replaced the fuel filter the car starts but when you take your foot off the gas it cuts off as lone as you keep pumping the gas pedal the car stays running what could it be
Could be a dirty throttle body or a problem with the idle air control valve.
Is the check engine light on ?
Yes the Check engine light is on
If the check engine light stays on after the engine starts, there should be trouble codes stored in the computer.
I would have it scanned for codes next. The trouble codes will tell you or a mechanic where to start looking.
If the check engine light stays on but you can't connect a scanner or code reader, either something is wrong with the connect plug, or the computer, or the person using the scanner.
There should be codes stored if the light stays on with the engine running.
×
SOURCE: car will stall when you take your foot off the gas
SCAN CAR SOUND LIKE IDLE SPEED CONTROL PROBLEMS.
SOURCE: check engine light stay on code PO107 veh.1996
P0107 map sensor circuit low- the map sensor sends signal to computer for control of fuel injection, it's on firewall side of engine, above right valve cover(firewall side) little black rectangular box with 3 wire connector and a vacuum line hooked to it. if it's vacuum line is ok -there is another connection at other end of hose/plastic tube make sure that vaccum supply to sensor is good, if it is, sensor probably bad can check out but not outside a shop or a computer diagnostics. if vacuum supply is good i'd probably just try a sensor
322 views
Usually answered in minutes!
I had it put on a machine an all they got was no connection and error messages
×