SOURCE: jeep wrangelr Crank Position Sensor
wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.
SOURCE: 2006 jeep wrangler check engine light came on it
There is a software update for the PCM that addresses this issue. TSB 18-028-06
SOURCE: replace 1995 jeep wrangler catalytic converter
If it has flanges on both ends, just unbolt it and replace. If it has welded pipes you will need to cut it off and use adapter sleeves and clamps. Really not rocket science...at worst, you may need to remove the hangars on the rear portion of the system to get enough room to install.
SOURCE: I can not find the flasher relay on my 2006 jeep wranger?
remove shroud around signal and wiper switch,and it is between them
SOURCE: how do i change out the knock sensor on a 2006 chevy colorado
You didn't list your engine size so please pick the applicable to your motor size:
Removal & Installation
2.8L & 2.9L Engines
To Remove:
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)
To Install:
285 views
Usually answered in minutes!
×