Interstate driving. cruise will constantly shut off. Have to reset it. Some days it doesn't work at all. Don't know where to start looking
SOURCE: 2001 S-10, Blowing "ECM Batt" fuse after running for about 30 min
that fuse feeds power to fuel pump relay circuit that feeds pump could be defective pump,or damaged circuit wires that shorts out! and not a good idea to put higher fuse in circuit could cause more damage to circuit! but i know when your stuck, u do what it takes,so inspect circuit related to fuse,
SOURCE: Cruise control stopped working
if the fuses are ok then i would say that there is a distruption between the cruise module vehicle speed sensor and the computer(ECM). unfortunately this is something only a qualified tech with diagnostic equipment can correct. i'm sure there are stored fault codes that the tech needs to check and reset. it's been my experience that oftyen times when this problem happens it has to do with the transmission control module which dictates how the engine and the transmission sync up to shift properly and your speed is measured through the transmission circuit thus the cruise control circuit is slaved to that.anymore questions feel free to contact me . just click my user tab on this site
SOURCE: Cruise control on 98 chevy venture stops working
The Venture uses an electronic Cruise Control and doesnt require vacume. I would suspect the cruise module under the hood, or the lever on the steering colum to be bad.
Testimonial: "You're right on the no vacuum part. I kind of suspected the unit under the hood myself, but was hoping there might be a cheaper fix. :-) Thanks 4 info"
SOURCE: I have a 1992 chevy 3500 with a 454 and a 4l60e
it sould been drove in 3 not in odrive when in 4x4 check trans scencer it controls the shifting and ing
153 views
Usually answered in minutes!
right
×