Trying to change timing belt...screws are loose but not enough room to remove them...any ideal how to get this metal flane off the timing belt to change it
SOURCE: How to replace a altenator belt on a 1995 plymouth neon
I had to put my 95 on ramps to make it easier to see. You have to loosen top adjustment nut, then in behind alternator is a bolt that goes through a plate that you have to turn clockwise, to tighten. I found it easier to see form under on ramps. You may have to loosen lower pivot bolt slightly too.
SOURCE: 2000 Plymouth neon shaking right front tire/wheel
This could be a lot of things, CV joint, tie rods, wheel bearings, even loose lug nuts.
SOURCE: 2001 Plymouth neon needs tensioner assembly
Most tensioners have a bolt on the other side of the twnsion pulley, if not you have to replace the tensioner with the base.
SOURCE: removing the valve body on a transmission on a 1998 plymouth neon
Check for DETENT CABLE this is Normally what hangs one Up at this Point of Disassemble of VB.
Testimonial: "Thank you very much this was extremely helpfull"
SOURCE: I just resently replaced a brken timing belt on my 96 neon
Neons used a DOHC interference type engine. I hate to tell you this, but the valves are bent, and your entire valve train (possibly your cylinder head) needs to be repaired or replaced all together.
95 views
Usually answered in minutes!
×