SOURCE: 2001 silverado 4x4 abs brake keeps coming on
in these trucks if the front abs activates at low speeds it is normally because of the wheel speed sensors in the front hubs. easy fix is to remove wheel speed sensor from wheel bearing. clean and file cast surface of bearing to allow sensor to move closer to internal reluctor ring. what happens is over time the casting rusts and creates a larger gap. please rate if this works.
SOURCE: 00 Chevy Silverado... ABS EBCM diagram help??? Brake line hookups
Hello,
I hope this helps.
Thank You,
Roy
SOURCE: how do I replace the transmission coolant lines
Take a small 90 degree pick. Inspect the fitting closely. Use the pick to "roll" the retaining clip off the fitting. The line will simply pull once this is done. U can install the clip first on reinstallation (inspect them closely) and then simply push the line into the fitting. It will "click" into place. Note u will have to orient the line perfectly to push in.
SOURCE: interchange body parts with 2001 Silverado 2500
1999 through 2002 Chevrolet Silverado or 1999 through 2002 GMC Sierra.
SOURCE: 2000 Chev Silverado 2500, Brake
Try opening a front bleeder and depress the pedal ALL the way,should feel a light "tic" as it reaches the bottom,close the bleeder and try to bleed the rear again,but instead of pumping ,just take the master cover off ,open the rear bleeders and wait 10 min or so for the fluid to gravity bleed out the air. Thinking the proportioning valve is tripped so no fluid is allowed to reach the rear,opening the front should reset the valve . If there is alot of air the valve will just trip again if you pump the pedal,hence the gravity bleed.
1,110 views
Usually answered in minutes!
×