Where is the fuse for the dash lights! they just went out checked all fuses even under the hood! cant find a fuse for the dash lights
SOURCE: No tail lights, tag light, dash board lights in 97 Nissan Maxima
If you don't have a manual, just get a test light, and ground it to your door hinge. At the back of every fuse, you will see part of the metal filament showing through. Touch your test light to each side of the fuse. You should have power to both sides of every fuse (when your key is on). If no voltage on one side, the fuse is burnt.
SOURCE: Dashboard and tail lights out on 97" Nissan Sentra
I took my pathfinder to U-HAUL and asked them to check the towing lights. There was a pinched wire by my tail light and they cut it and changed it out for me, it was $5. I am so glad that I didnt take it to Nissan. My second step was going to be getting a new dimmer switch..but the guy who worked on my car said that wouldnt be the problem. He also told me that replacing a fuse that kept blowing out was dangerous and after the first time to get it checked out. Learn something new every day!!
SOURCE: 1996 Nissan Maxima Clock, Dome Light & Radio went out not working
you need to check the fuse some ?
SOURCE: Nissan Maxima 2000 - no dash board lights, no tail
had same problem on my supra come to find out it was a relay switch back between the tailights
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
4,875 views
Usually answered in minutes!
×