Question about Honda Ridgeline

Open Question

How to replace side mirror on Honda Ridgeline

Passenger side

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

william moody

  • 713 Answers

SOURCE: How to replace a the passenger side mirror

will have to remove the door panel unless it has a small piece in the upper corner by the mirror. should have three 10mm nuts that hold it on.

Posted on Aug 27, 2009

Testimonial: "Thanx for your very quick response!!!"

Ad

super_guy

  • 1986 Answers

SOURCE: Replace passenger side electric mirror

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Anonymous

  • 1 Answer

SOURCE: passenger side mirror

If you need to replace the entire mirror - it's a little involved. First you need to take the upper extension panel off from behind the mirror (black triangle) - just pull it of starting at the top. It will snap back on later. Next - remove the different screws holding the door panel in place (not the ones behind the mirror yet!) One is under the handle (pull it out and pull out the filler panel - small plastic thing that has a hole to pry it out). Then take off the rear red light - also pops off - and remove that screw. Finally - pick up the rubber filler where your fingers pull the door shut and remove these torx bolts.

Now is the tricky part. Snapp off the entire interior panel. It will pop off - but very difficult. It will sound like it is breaking! Start at the outer bottom corner - and use a door panel remover tool - check Amazon or E-bay - to keep from breaking things. Pull it out from all around the bottom and sides and then lift it up over the door lock. It good to have a friend help here. The panel will still be held on by a cable - that is your door release - leave it alone and let the panel hang by it (or better, put a box under it to rest on).

Now...remove the three bolts holding the mirror on - have a friend help hold the mirror while you do this or it will scratch your new car! Since the inner panel is off - you can also disonnect the mirror plus and remove it. It sounds silly - but the only reason to remove the door panel is to unplug it!

Get you new mirror and reverse the steps.

If you are just replacing the glass (non-heated) - get a replacement from the dealer. Adjust the mirror all the way to the inside and reach behind and pop it off. CAREFUL - put tape over the entire glass as it will likely break even more! Remove your connectors if heated - and replace (and reconnect) with your new glass. It just pops back on!

Replacing glass is easy - just be careful of cheap imitations on e-abay). And never use cheap flat glass on the passenger side! The DOT has special requirements for mirror glass - buy it from gmpartsdirect.com or your local dealer.

kb

Posted on Jan 08, 2009

super_guy

  • 1986 Answers

SOURCE: How do I replace broken 2002 buick century passenger side mirror?

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Anonymous

  • 1 Answer

SOURCE: How to replace passenger side mirror on 2007 Camry

To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hot air from drivers side cool air from passenger side


Driver's side blows hot air; passenger side cold air - Hyundai ...

www.hyundai-forums.com/.../294097-drivers-side-blows-hot-air%3B-pa...
Jul 29, 2014 - 3 posts - ‎3 authors I soon noticed that the driver's side blows warm air and the passenger side blowscold air as it should. No amount of adjusting the temp control ...

Hot air on driver side vents - Cold on passenger side - Page 3 ...

www.odyclub.com/.../46646-hot-air-driver-side-vents-cold-passenger-si...
May 9, 2012 - 16 posts - ‎10 authors I have a 2009 EXL Odyssey that just is doing the same thing (warm air on drivers side, cold on passenger). I checked freon levels and ...

Oct 15, 2015 | 2009 Hyundai Sonata

1 Answer

Passenger window wont roll down with either switch but motor is good and getting power


New switch for the passenger side. The drivers side switch may be wired through the passengers side switch witch will make it not work if the passengers side switch is bad. Just a thought. Hope this helps.

Nov 10, 2013 | 2005 Chevrolet TrailBlazer

2 Answers

Question; Is the right side of a 2006 Toyota Tacoma V6 engine on the driver side or passenger side?


the banks of a v engine are determined from the drivers seat in a convention car and in a east-west car the no 1 bank is closest to the firewall so from the drivers seat no 1 bank will be in front of the driver ( LH drive cars) or in front of the passenger in RH drive cars

Oct 30, 2017 | Toyota Cars & Trucks

1 Answer

Passenger side windshield wiper working slow


there is 2 wiper motors . 1 for the drivres side and the other for the passenger. sounds like a bad passenger side motor

Dec 21, 2012 | 2005 Chrysler Pacifica

1 Answer

2007 passenger side widow won't go up


Faulty switch on passenger door, take out and replace or clean with crc cleaner

Oct 09, 2012 | 2007 Nissan Altima 3.5 Sedan

1 Answer

Firing order mitsubishi 3.5


Mitsubishi Montero 3.5 V-6n24 valve

Looking from the front of engine to the rear on the passenger side 1-3-5
Looking from the front of the engine to the rear on the drivers side 2-4-6


The engine has coil over plug with coils only on the drivers side. The spark is shared via spark plug cables to the plugs on the passenger side. So If you are replacing the spark plug cables:

#2 cyl.coil drivers side shares spark with #5 passenger side-
#4 coil drivers side shares spark with #1 passenger side-
#6 coil drivers side shares spark with #3 cylinder passenger side.

Mar 17, 2012 | Mitsubishi Diamante Cars & Trucks

1 Answer

I'm having some problems on my #4 cylinder on my 5.4 triton engine coil pack in my 2003 Ford Expedition. How do I identify which coil is #4?


Firing Orders; (5.4L)
************* Firewall ************
(Passenger Side) 4 * 8 (Drivers Side)
(Passenger Side) 3 * 7 (Drivers Side)
(Passenger Side) 2 * 6 (Drivers Side)
(Passenger Side) 1 * 5 (Drivers Side)
************ Radiator *************

Firing order
1 - 3 - 7 - 2 - 6 - 5 - 4 - 8


Sep 20, 2011 | 2003 Ford E150

1 Answer

What is the firing order in a 1997 Ford Mustang 3.8 V6


1997 Ford Mustang 3.8 liter V-6 VIN "4"

Cylinder # passenger side radiator to firewall, 1-2-3
Cylinder # passenger side radiator to firewall, 4-5-6

Coil numbering
Radiator side, passenger to driver side 5-6-4
Fire wall side, passenger to driver side 1-2-3

Thank you for using fixya and good luck

Apr 11, 2010 | 1997 Ford Mustang Cobra

1 Answer

I have a problem with the Cylinderkit number 3 of my truck but do not know which is the number 3 can Cylinderkit shown how Cylinderkit number 3


Firing Orders; (4.6L - 5.4L)

Firing Order: 1-3-7-2-6-5-4-8 Distributorless ignition system ************* FIREWALL REAR OF ENGINE************
(Passenger Side) 4 * 8 (Drivers Side)
(Passenger Side) 3 * 7 (Drivers Side)
(Passenger Side) 2 * 6 (Drivers Side)
(Passenger Side) 1 * 5 (Drivers Side)
************* RADIATOR FRONT ************

Jan 05, 2010 | 1997 Ford Expedition

2 Answers

What is the proper way to rotate the tires on my 1998 Honda CR-V ?


the proper way is to take rear passenger tire up to the front passenger side, the rear driver side up to front driver side. The front driver side to rear passenger side and front passenger side to rear driver side.

Sep 25, 2009 | 1998 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

3,026 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...