How do I change the water pump on my 1991 mercury cougar?
SOURCE: water pump location on the 2.5L V6 engine 1999 cougar
It is located on top of the engine under the throttle body, it sucks, plan on a whole day if you are a good machanic.
SOURCE: 2000 mercury cougar wont start
what is anti-theft light doing? It should come on solid for about 2 sec after you turn the key on then turn off. If it is flashing after this then it is not seeing the computer chip in the key and you have a PATS problem.
SOURCE: 1999 Mercury Cougar Serpentine belt
try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you
SOURCE: can you bleed the water cooling system on 1999 mercury cougar
This is extremely important on some cars, for instance my BMW. 1. Have the car parked in a slight uphill slope. Make sure there is enough coolant in the expansion jar.
2. Start the engine and wait for the thermostat to open (upper radiator hose becomes warm).
3. Open up the radiator bleeding nipples slightly with a large screwdriver (bleeding nipples normally made of plastic with a '+* for a screwdriver to fit, at the highest points in the cooling circuit).
4. Allow air bubbles to fizzle out until you get a steady stream of coolant leaking out, use rags to capture leaking coolant.
5. Then close the bleeding nipples, switch off the engine and wait a few minutes for pressure to come down.
6. Open up the cap on the expansion vessel carefully and fill just below the "hot" marking.
7. Check levels again after a few miles and refill further if needed.
Done.
83 views
Usually answered in minutes!
×