Remove drive side door panel
There are screws you have to remove. make sure you've found and removed all of them. then the door is held in with clips from the back side. work a pry bar or a long flat screw driver around the edges to pop them loose then you should be able to get your hands behind it to find the other clips. in some cases the handles have to come off before the panel can be removed
SOURCE: 1999 buick regal odometer light fading
1999 buick custom century odometer light has gone out. what is the cost to repair? is there a simple way to repair or replace the lighting?
SOURCE: Remove right rear door panel 2003 Buick LaSabre
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 99 Buick LeSabre, how do I remove driver side door panel to replace power window motor?
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: water on passenger side floor of Buick Regal
U need to clear the AC condensation drain, crawl under the car on the passenger side and near the base of the engine firewall u will find a drain pipe, (about 3/4") clear t and the water will stop going on the passenger floor.
SOURCE: how do u install a side mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
285 views
Usually answered in minutes!
×