Only at low speeds my pontiac aztek stalls and the battery light comes on
SOURCE: where is blower motor resistor
There is a resistor pack for the fan speed in the ductwork near the fan.. It is very easy to replace once it is located. Ussually there are either one or two 5.5mm screws holding it in place. Once you get it out you will notice the resistors that are burnt.
SOURCE: Pontiac Aztek running hot
You may want to do a inspection of your cooling system, here's a list that might help,
SOURCE: Rear Wheel Bearing Repair; 2005 pontiac aztek
Remove the brake caliper
Remove the disc, (rotor)
Remove the 34mm nut on the axel shaft
Remove the three (3) bolts from the back side
You will need a wheel puller (three jaw will work well)
Place the puller over the hub and tighten, this will push the shaft out of the hub. Now you have to pull the hub assy. out of the mounting bracket. I found hitting each side,of the hub with a lead hammer to work well. Don't forget to disconnect the ABS senser on the back side of the hub assy.
Do not over tighten the 34mm axel nut when you install the new assy. If you use an impact whrench on it you will damage the bearing.
SOURCE: 2002 Pontiac Aztek - AWD disable light and Anti Lock Light
AWD disabled from a sensor unit in rear differential that senses high temp. This thing is over $300. Whine is from fluid. Need to change fluid. This versatrack fluid is about $40 per bottle and you need 3 bottles. Thumping noise is from loose rear knuckle bushings. These are part of the entire rear knuckle assy. and you must replace complete knuckle.
SOURCE: 2002 Aztek Service engine light on & high beam indicator flashes
The high beam light flashing means you have a high beam burnt out. It flashes when you put it in gear because your high beams actually double as your daytime running lights, only on a lower power.
774 views
Usually answered in minutes!
Yes the check engine light is on when the engine is running and the battery light comes on after the engine dies. How much am I looking at for a idle air control
and usually when turning corners and it looses power to turn the steering wheel
I would check the computer for trouble codes first. The codes should point you in the right direction to look for the problem.
×