Type of antifreeze for 1992 jeep yj - 1992 Jeep Wrangler

SOURCE: 1992 YJ clutch fluid disapears.

It's probably your slave cylinder. On my '89 it was located in the clutch housing. You have to take the tranny off to get access to it. This is probably why the fluid is "disappearing." I'd suggest changing the clutch while you're at. They sell kits for this at auto parts stores.

SOURCE: 1992 4 cylinder Jeep YJ sputters while driving.

try this site for resolve oil and resolve petrol system addertive for old cars. amitech . its good i typed into computer sludge in petrol tank but they have lots of products that might help before you do anything as these products clean the engine

SOURCE: Jeep 1992 yJ Outside Door Handle

ok, the inside panel is cardboard with faux leather. remove the screws holding on the inside handle and the frame of the doorlatch.

there is a plastic joint that connects the two rods that actuate and open the door. the rods are bent at the end to slip into the white plastic joint. this design is stupid and often times that joint can break, or the rods fall out. solution is to reattach them together and wrap mechanics wire or bend the very ends of the rods so they wont come out.

its something i cant really explain, but the design is straight forward. also, keep track of the threads on the rod that connects to the claw that meets the striker on the frame of the jeep. if for any reason its not adjusted properly, it will not latch properly.

SOURCE: 1992 jeep yj will not turn over

Try jumping the solenoid,pull the actuator wire off the solenoid(the small one)This will engage the starter so make sure your in nuetral or park,run a wire from the solenoid actuator to the positive battery post,if the starter engages your ignition switch or starter relay have become faulty,if the starter does'nt engage the solenoid has gone bad.Post back if you need more help.

SOURCE: What's your problem?what type of antifreeze do i use r a 1996 Jeep Grand Cherokee

find a brand that says that it is compatable with any other brand, and that it won't harm metals such as aluminum,copper,and so on.
you can buy it pre mixed if you wish ,i prefer to mix it myself.
brand isn't important as long as it meets the requirements listed above.
unless the warenty requires it
hope this is helpfull !