Lights flash;interior lights flash, auto door locks stick; alarm goes off
SOURCE: How do I remove the ignition lock cylinder from a
REMOVAL
INSTALLATION
IMPORTANT:
Actuator blade within ignition module housing must be in ACC position to
install lock cylinder assembly. If rotated, replace it to ACC position,
using needle nose pliers.
Testimonial: "Great information! Thanks for the help. Now I can get the ignition rekeyed to match the doors after the dealer changed the switch."
SOURCE: 2003 Saturn Vue rear liftgate won't open
The easy part is you just need the latch for the liftgate. The hard part is getting to it and opening the liftgate to replace the latch. You should be able to pull the liftgate trim off most of the way with the gate closed and try to manually actuate the latch to open the gate. You may have to go so far as breaking the latch from the inside to open the gate and then replace your latch.
SOURCE: 2005 Saturn Vue - Airbag dash light intermittently on
THE AIR BAGS TURN OFF AND ON BECAUSE IT GOES BY WEIGHT... AND IT ALSO GOES OFF WHEN YOU ARE GOING A LOWER SPEED AND WHEN YOU ARE GOING A HIGHER SPEED THEY WILL COME BACK ON.
SOURCE: 2004 SATURN ION Alarm goes off without being armed.
if you have a sunroof, the sunroof drains are clogged. either way you may have a bad door switch. you will have to pull each one out and look for corrosion at the plug. the fronts are most common, they are on either side of the dashboard.
SOURCE: 2002 Saturn Vue rear passenger door will not lock
It sounds like the the linkage, actuator (power locks), or the mechanism has broken or become dislodged.
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Pull back the weather seal and you should see everything and hopefully see the cause.
630 views
Usually answered in minutes!
×