Question about 2008 Chrysler 300

1 Answer

What fuses or relays would cause a hesitation when starting car

When turning the the key. The car hesitates to start. I can hear the relays under the hood click 3-4 times, then nothing. I have tried jumping off the car. The car runs fine afterward. Then when you turn the car off. It will start 1-2 times. Then it will start to hesotate again. I have checked all battery connections. I am still unsure of what relays do what. I have the diagram for the fuses. But, Not of what the relays do

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 819 Answers

Are you sure it is relays and not the starter solenoid? A weak battery gives same symptom.

Posted on Jul 14, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: 2002 Chrysler Sebring will not start

Mine did the click, click and the timing chain had snapped. If any of you have 2.7 litre engines plan on an engine rebuild or a replacement. Look up the 2.7 engine size along with oil sludge and timing chains. Grab yourself a towel to sop up the tears. This car is 100% garbage and I'm shopping for another non Chrysler product this week.

Posted on Oct 14, 2008

Anonymous

  • 51 Answers

SOURCE: can't find turn signal relay.

check the hazard switch on some cars its part of the hazard switch or if the conection is bad they none of it will work.

Posted on Mar 16, 2009

Hightower971

Calvin Hart

  • 183 Answers

SOURCE: 2005 Chrysler town & country touring won't turn over.

Sounds like you need a starter, or you have a loose wire somewhere under the hood.

Posted on Apr 25, 2009

Anonymous

  • 8 Answers

SOURCE: 2002 Chrysler Sebring Convert wont turnover

If you're not hearing a click from the starter check for a starter relay. May be burned out! DO you hear the fuel pump kick in when you turn the key on? If not something might have triggered your security system and locked you out!

Posted on Jul 10, 2009

jturcotte

Jeffrey Turcotte

  • 8984 Answers

SOURCE: 2004 chrysler sebring GTC convertible,

Your starter is drawing too much current. Recommend you replace the starter. Perhaps you can do it yourself using my tips at http://www.fixya.com/cars/r5973094-starter_replace.
Please reply if you have more questions.

9763ccd.gif

Posted on Sep 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

12 code reading after replacing fuel pump, filter, relay and new battery in 94 zj (5.2 4×4) Ran for approx 50 miles (hesitant at best) then bogged out and died. now wont turn over (some sort of Fuel...


To start with, code 12 is loss of battery voltage within last 100 engine starts, which is normal if you had the battery disconnected, code 55 just means the computer has completed testing. I'm sure your problem is fuel related. Why did you replace all that stuff?
Listen close when you turn the key on, you should hear the fuel pump run for a couple of seconds to prime the rail. If not, start at the fuel pump connector and check for power when someone turns on the key. If there is no power, work backward toward the battery. You should check with a dealer as Chrysler/Jeep had a recall on the relay /fuse box under the hood(power control module), which would fail causing problems such as you are describing. They are really expensive, and the company was sued due to the many failures. If yours is bad, and you get no factory help, try to find a salvage part. I have installed used ones before that worked OK, but there is no guarantee how long.

Feb 03, 2018 | Jeep Cars & Trucks

1 Answer

SUV hesitates but will not crank


Car hesitates to start at crank - AnandTech Forums

forums.anandtech.com > Social > The Garage

AnandTech
Oct 2, 2007 - 7 posts - ‎6 authors
wait... does it hesitate to crank or does it hesitate to fire while being cranked? ... If itcranks OK but hesitates to fire, but is fine after it is going and then ... to want to keep the money that you've earned, but not greed to want to ...

Delay before crank start and no starting. : Mercedes-Benz ...

repairpal.com > Problems > Mercedes-Benz > ML350
Car has left me stranded, where key is in the on position but nothing registers ... While turning the key ignition will not crank over at times will take from 5 to 10 .... it off for a short errand and go right back to start is when I notice more hesitation.

Truck will turn over but won't crank (auto, spark plugs, fuel ...

www.city-data.com > City-Data Forum > General Forums > Automotive

Jan 07, 2016 | Cars & Trucks

1 Answer

Dodge Stratus dies while driving


Sounds very much like your fuel pump is done for. After it runs for a bit it starts to get hot & quiets working once it cooled down it started working again. This is very common but more frequent if fuel in tank is low. It realy will take a fuel system test to verify.

Jul 12, 2013 | 2005 Dodge Stratus Sedan

2 Answers

What could cause a low rpm hesitation or an acceleration hesitation on a 1998 toyota tacoma 4 cylinder 4X4


u could very well need a new fuel pump or fuel pressure regulator, or u might just need a full tune-up done

Jun 16, 2010 | 1998 Toyota Tacoma

3 Answers

My truck was running great no sign of any problem.


bad connections to the battery or it might be dead might wanna check the starter if ur hearing a clicking noise

May 28, 2010 | 2006 Ford F-150

1 Answer

Hesitates start an when i stop it cuts off


you should not have to work the gas pedal to start this car. It has an electric fuel pump. When you turn the key on to start it can you hear a "whirring" sound coming from the back of the car? Get your fuel pump checked.

Mar 10, 2010 | 2000 Dodge Avenger

2 Answers

Testing fuel pump relay on a 90 corvette


when you turn the key into the on position not starting it you should hear the pump working

May 20, 2009 | 1990 Chevrolet Corvette

1 Answer

1997 F-250 won't start.


I assume you have enough gass.

What are the sounds you are hearing.
Does it tick or make the common sound before it starts the engine.

If it ticks and doesn't make the common sound it's plausible you have a problem with your "start engine" (don''t know the english term) or a problem with a fuse.

If it makes the common sound but doesn't start, check all the cables if its fitted. See if the filters are clean (especially the fuel filter).

Jan 09, 2009 | 1997 Ford F250 SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...